Abstract:Copper intrauterine device is one of the most adopted contraceptive methods with high effectiveness (over 99 %), low cost, spontaneous reversibility and long-lasting usage. However, the side effects induced from the initial burst release of copper ions (Cu2+) hinder the continuation of the Cu-IUD made of Coarse-Grained Copper (CG Cu). We proposed to tailor the bio-corrosion behaviors of better control of Cu2+ release via the addition of bioactive Mg into the Ultra-Fine Grained (UFG) Bulk Cu. Thus, UFG bulk Cu with 0.4 wt.% Mg was produced via equal-channel angular pressing. The microstructures of the UFG Cu-0.4Mg was observed using electron backscatter diffraction and transmission electron microscopy techniques. The in vitro long-term corrosion behaviors in simulated uterine fluid, cytotoxicity to four cell lines, in vivo biocompatibility and contraceptive efficacy were all studied on CG Cu, UFG Cu and UFG Cu-0.4Mg materials. The results demonstrate that both the ultrafine grains and the addition of bioactive Mg into Cu contribute to the suppression of the burst release of Cu2+ in the initial stage and the maintenance of high level Cu2+ in long-term release. Moreover, the UFG Cu-0.4Mg also exhibited much improved cell and tissue biocompatibility from both the in vitro and in vivo evaluations. Therefore, the contraceptive efficacy of UFG Cu-0.4Mg is still maintained as high as the CG Cu and UFG Cu while the side effects are significantly eased, suggesting the high potential of the UFG Cu-0.4Mg alloy as a new upgrading or alternative material for Cu-IUD.<h3 class="u-h4 u-margin-m-top u-margin-xs-bottom">Statement of significance</h3>The side effects from burst release of Cu2+ at the initial implantation stage of Cu-containing intrauterine devices (Cu-IUD) is one of the main drawbacks of these devices. In this work, an ultra-fine-grained Cu (UFG Cu) alloyed with a low amount of bioactive Mg was used for a Cu-IUD. The UFG Cu-0.4Mg alloy exhibited suppressed burst release of Cu2+ at initial implantation, while active Cu2+ release for long-term usage was maintained, comparable to coarse-grained pure Cu. Furthermore, the UFG Cu-0.4Mg alloy displayed significantly improved biocompatibility with human uterus cells and a much decreased inflammatory response within the uterus. Therefore, the side effects from Cu-IUD were eased, while high antifertility efficacy of the UFG Cu-0.4Mg alloy was maintained. The UFG Cu-0.4Mg alloy is promising for Cu-IUD.

Antifertility Effectiveness of a Novel Copper-Containing Intrauterine Device Material and Its Influence on the Endometrial Environment in Rats.

Effect of a novel copper-containing intrauterine device material on the endometrial environment in rabbits.

The Antifertility Effectiveness of Copper/low-Density Polyethylene Nanocomposite and Its Influence on the Endometrial Environment in Rats.

Alterations in the Endometrium of Rats, Rabbits, and Macaca Mulatta That Received an Implantation of Copper/low-Density Polyethylene Nanocomposite

Effect of Implanted Cu/low-density Polyethylene Nanocomposite on the Morphology of Endometrium in the Mouse

Antifertility Effectiveness of a Novel Polymer Matrix Composite and Its Influence on the Endometrium in Rhesus Macaques (macaca Mulatta).

Studies of Acute and Subchronic Systemic Toxicity Associated with a Copper/low-Density Polyethylene Nanocomposite Intrauterine Device

Biological Evaluation of the Copper/Low-density Polyethylene Nanocomposite Intrauterine Device

Effects of A Novel Complexing Copper-containing IUD on Endometrial Morphology in Rats

Feasibility evaluation of a Zn-Cu alloy for intrauterine devices: In vitro and in vivo studies

Effective easing of the side effects of copper intrauterine devices using ultra-fine-grained Cu-0.4Mg alloy

Mitigating Adverse Effects of Cu-containing Intrauterine Devices Using A Highly Biocompatible Cu-5Fe alloy

A Novel Copper/Polydimethiylsiloxane Nanocomposite for Copper-Containing Intrauterine Contraceptive Devices

Correlative investigation of copper/low-density polyethylene nanocomposite on the endometrial angiogenesis in rats

Effective Inhibition of the Early Copper Ion Burst Release with Ultra-Fine Grained Copper and Single Crystal Copper for Intrauterine Device Application

Feasibility evaluation of a Cu-38 Zn alloy for intrauterine devices: In vitro and in vivo studies

Cupric ion release controlled by copper/low-density polyethylene nanocomposite in simulated uterine solution.

Effect of the Loading and Size of Copper Particles on the Mechanical Properties of Novel Cu/Ldpe Composites for Use in Intrauterine Devices

In vitro release of cupric ion from intrauterine devices: influence of frame, shape, copper surface area and indomethacin

A Preliminary Morphometric Study on the Endometrium from Patients Treated with Indomethacin-Releasing Copper Intrauterine Device

Comparative Study on Contraceptive Efficacy and Clinical Performance of the Copper/low-Density Polyethylene Nanocomposite IUD and the Copper T220C IUD