Abstract:Copper intrauterine device is one of the most adopted contraceptive methods with high effectiveness (over 99 %), low cost, spontaneous reversibility and long-lasting usage. However, the side effects induced from the initial burst release of copper ions (Cu2+) hinder the continuation of the Cu-IUD made of Coarse-Grained Copper (CG Cu). We proposed to tailor the bio-corrosion behaviors of better control of Cu2+ release via the addition of bioactive Mg into the Ultra-Fine Grained (UFG) Bulk Cu. Thus, UFG bulk Cu with 0.4 wt.% Mg was produced via equal-channel angular pressing. The microstructures of the UFG Cu-0.4Mg was observed using electron backscatter diffraction and transmission electron microscopy techniques. The in vitro long-term corrosion behaviors in simulated uterine fluid, cytotoxicity to four cell lines, in vivo biocompatibility and contraceptive efficacy were all studied on CG Cu, UFG Cu and UFG Cu-0.4Mg materials. The results demonstrate that both the ultrafine grains and the addition of bioactive Mg into Cu contribute to the suppression of the burst release of Cu2+ in the initial stage and the maintenance of high level Cu2+ in long-term release. Moreover, the UFG Cu-0.4Mg also exhibited much improved cell and tissue biocompatibility from both the in vitro and in vivo evaluations. Therefore, the contraceptive efficacy of UFG Cu-0.4Mg is still maintained as high as the CG Cu and UFG Cu while the side effects are significantly eased, suggesting the high potential of the UFG Cu-0.4Mg alloy as a new upgrading or alternative material for Cu-IUD.<h3 class="u-h4 u-margin-m-top u-margin-xs-bottom">Statement of significance</h3>The side effects from burst release of Cu2+ at the initial implantation stage of Cu-containing intrauterine devices (Cu-IUD) is one of the main drawbacks of these devices. In this work, an ultra-fine-grained Cu (UFG Cu) alloyed with a low amount of bioactive Mg was used for a Cu-IUD. The UFG Cu-0.4Mg alloy exhibited suppressed burst release of Cu2+ at initial implantation, while active Cu2+ release for long-term usage was maintained, comparable to coarse-grained pure Cu. Furthermore, the UFG Cu-0.4Mg alloy displayed significantly improved biocompatibility with human uterus cells and a much decreased inflammatory response within the uterus. Therefore, the side effects from Cu-IUD were eased, while high antifertility efficacy of the UFG Cu-0.4Mg alloy was maintained. The UFG Cu-0.4Mg alloy is promising for Cu-IUD.

Release of Cupric Ion and Drugs of Yuan Gong Medicated Cu-IUDs in Simulated Uterine Solution

Study on the release behavior of cupric ion in copper-bearing intrauterine devices

Cupric Ion Release and Cytotoxicity for Yuangong Cu-IUDs and the Release Behavior of Indomethacin for Medicated 220 Cu-IUD

Release of copper and indomethacin from intrauterine devices immersed in simulated uterine fluid.

In vitro release of cupric ion from intrauterine devices: influence of frame, shape, copper surface area and indomethacin

Release behavior of cupric ions for TCu380A and TCu220C IUDs.

Cu Ion Release and Cell Damage Effect of Cu-Containing Iuds with Different Surface Areas of Copper

Cupric Ion Release of Different Cu-containing Intrauterine Device in Simulated Uterine Solution

The Release of Cupric Ion in Simulated Uterine: New Material Nano-Cu/low-density Polyethylene Used for Intrauterine Devices

[Analysis the Cupric Ion Release Characteristics of Different Copper Raw Materials in Intrauterine Device in Vitro Using ICP Method].

Effective Inhibition of the Early Copper Ion Burst Release with Ultra-Fine Grained Copper and Single Crystal Copper for Intrauterine Device Application

Concentration-dependent Cytotoxicity of Copper Ions on Mouse Fibroblasts in Vitro : Effects of Copper Ion Release from TCu380A Vs TCu220C Intra-Uterine Devices

Cupric ion release controlled by copper/low-density polyethylene nanocomposite in simulated uterine solution.

Corrosion of wire and tube of copper-bearing intrauterine device in simulated uterine solution

Very Fine-Grained Cu-0.4Mg Alloy Improving Intrauterine Device

Effect Of Silicone Rubber Coating On Release Of Cu2+ From Intrauterine Device

Indomethacin/Cu/LDPE Porous Composite for Medicated Copper Intrauterine Devices with Controlled Release Performances

The evaluation of Shandong medicated copper T IUD for a period of 24 months

Effective easing of the side effects of copper intrauterine devices using ultra-fine-grained Cu-0.4Mg alloy

A Randomized Clinical Trial of Intrauterine Device MYCu

A Preliminary Morphometric Study on the Endometrium from Patients Treated with Indomethacin-Releasing Copper Intrauterine Device