Abstract:Al–15%Pb–4%Si–1%Sn–1.5%Cu alloys (mass fraction, %) were prepared by mechanical alloying (MA). Phase transformation and microstructure characteristics of the alloy powders were investigated by X-ray diffraction (XRD) and transmission electron microscopy (TEM). The results show that the nanocrystalline supersaturated solid solutions and amorphous phase in the powders are obtained during MA. The effect of ball milling is more evident to lead than to aluminum. During MA, the mixture powders are firstly fined, alloyed, nanocrystallized and then the nanocrystalline partly transforms to amorphous phase. A thermodynamic model is developed based on semi-experimental theory of Miedema to calculate the driving force for phase evolution. The thermodynamic analysis shows that there is no chemical driving force to form a crystalline solid solution from the elemental components. But for the amorphous phase, the Gibbs free energy is higher than 0 for the alloy with lead content in the ranges of 0–86.8at.% and 98.4–100at.% and lower than 0 in range of 86.8–98.4at.%. For the Al–2.25at.%Pb (Al–15%Pb, mass fraction, %), the driving force for formation of amorphization and nanocrystalline supersaturated solid solutions are provided not by the negative heat of mixing but by mechanical work.

Microstructure Analysis for Al-Pb Alloy of Preparation in Powder Metallurgy Processing

Investigation of a Hot-Pressed Nb–Ti–Al Alloy: Mechanical Alloying, Microstructure and Mechanical Property

Microstructure and Morphology of Al-Pb Bearing Alloy Synthesized by Mechanical Alloying and Hot Extrusion

Preparing Al -Pb Alloy by Mechanical Milling and Canning Extrusion

Study on Phase Transformation and Thermodynamic and Kinetic of Al-Pb Powder During Mechanical Alloying

Microstructure and Mechanical Properties of Selective Laser Melted Mg-9 Wt%al Powder Mixture

Microstructure and mechanical properties of powder metallurgy Be/Al alloy

Variation of mechanical properties and microstructures of Al-Pb mixed powder during mechanical milling

Microstructure and Wear Properties of Al–Pb–Cu Alloys Prepared by Mechanical Alloying

Formation of nanocrystalline and amorphous phase of Al-Pb-Si-Sn-Cu powder during mechanical alloying

Study on the nano-crystalline and amorphous Al-Pb series powders synthesized by mechanical alloying

Microstructural evolution and mechanical properties of an ultrahigh-strength Al−Zn−Mg−Cu alloy via powder metallurgy and hot extrusion

Preparation of Wearable Al-20pb Alloy by Powder Milling and Extrusion Densification

MICROSTRUCTURE AND WEAR PROPERTIES OF Al-Pb-Cu ALLOY SYNTHESIZED BY MECHANICALLY ALLOYING

Microstructure and Wear Properties of Al-Based Bearing Alloys Fabricated by Mechanical Alloying

Microstructure and mechanical properties of Ti–22Al–25Nb alloy fabricated by vacuum hot pressing sintering

Microstructure and Mechanical Properties of FeAl Intermetallics Prepared by Mechanical Alloying and Hot-Pressing

Microstructure and Properties of A Tial Alloy Prepared by Mechanical Milling and Subsequent Reactive Sintering

Characterization of pre-alloyed TiAl powder and its microstructure characteristics after hot-pressing

Microstructure and wear properties of nanocomposite Al-Pb-Cu alloy cold-rolled onto steel matrix

Investigation on the Microstructure Homogenization in A Tial Based Alloy Prepared by Elemental Powder Metallurgy