Abstract:Purpose Surface configuration at the interface between two materials makes a huge difference on thermal resistance. Thermal transient analysis is a powerful tool for thermal characterization of complex structures like LEDs. The purpose of this paper is to report the influence of surface finish on thermal resistance. Design/methodology/approach Surface of heat sink was modified into two categories: machined as channel like structure; and polished using mechanical polisher and tested with 3W green LED for thermal resistance analysis. Findings The observed surface roughness of rough and polished surface was 44 nm and 4 nm, respectively. Structure function analysis was used to determine the thermal resistance between heat sink and MCPCB board. The observed thermal resistance from junction to ambient (R thJA ) value measured with thermal paste at 700 mA was lower (34.85 K/W) for channel like surface than rough surface (36.5 K/W). The calculated junction temperature ( T J ) for channel like surface and polished surface was 81.29°C and 85.24°C, respectively. Research limitations/implications Channelled surface aids in increasing bond line thickness. Surface polishing helps to reduce the air gaps between MCPCB and heat sink and also to increase the surface contact conductance. Practical implications The proposed method of surface modification can be easily done at laboratory level with locally available techniques. Originality/value Much of the available literature is only concentrating on the design modification and heat transfer from fins to ambient. There was little research on modification of top surface of the heat sink and the proposed concept would give good results and also it will make the material cost reduction as well as material too.

Analysis and Measurement of Thermal Resistance Induced by LED Bonding

Analysis of thermal spreading resistance in high power LED package and its design optimization

Thermal Analysis and Design of High-Power LED Street Light

Experimental Study and Taguchi Analysis on LED Cooling by Thermoelectric Cooler Integrated with Microchannel Heat Sink

Study of LED Thermal Resistance and TIM Evaluation Using LEDs with Built-in Sensor

Study on The Measurement for the Thermal Resistance of Power LED

Thermal Resistance Evaluation of High Power LED

A New Non-Contact Method Based on Relative Radiation Intensity for Determining Junction Temperature of LEDs

Junction Temperature Measurement and Luminous Properties Research of High-Power LED

Effects of Bonding Materials on Optical–Thermal Performances and High-Temperature Reliability of High-Power LED

Failure Analysis Of Die-Bonding Interfaces Between Led Chip And Heat Sink

Experimental Study of Measuring LED's Temperatures Via Thermocouple

Analysis of Junction Temperatures in High-Power GaN-based LEDs

Thermal resistance studies of surface modified heat sink for 3W LED using transient curve

Achieving Accurate Electro-Optical-thermal Measurements of High-Power LEDs

Photoelastic Measurement of Strain Induced by Die-Bonding of GaAs Chip on a Copper Heatsink Plate

An Engineering Method to Estimate the Junction Temperatures of Light-Emitting Diodes in Multiple LED Application

In-Situ Measurement of Junction Temperature and Light Intensity of Light Emitting Diodes with an Internal Sensor Unit

Heat transfer in high-power LED with thermally conductive particle-filled epoxy composite as thermal interface material for system-level analysis

Thermal analysis and testing of multi layer ceramic-metal packaged LED

Application of Thermal Resistance Network in Thermal Analysis of LED Lamps