Abstract:Purpose Surface configuration at the interface between two materials makes a huge difference on thermal resistance. Thermal transient analysis is a powerful tool for thermal characterization of complex structures like LEDs. The purpose of this paper is to report the influence of surface finish on thermal resistance. Design/methodology/approach Surface of heat sink was modified into two categories: machined as channel like structure; and polished using mechanical polisher and tested with 3W green LED for thermal resistance analysis. Findings The observed surface roughness of rough and polished surface was 44 nm and 4 nm, respectively. Structure function analysis was used to determine the thermal resistance between heat sink and MCPCB board. The observed thermal resistance from junction to ambient (R thJA ) value measured with thermal paste at 700 mA was lower (34.85 K/W) for channel like surface than rough surface (36.5 K/W). The calculated junction temperature ( T J ) for channel like surface and polished surface was 81.29°C and 85.24°C, respectively. Research limitations/implications Channelled surface aids in increasing bond line thickness. Surface polishing helps to reduce the air gaps between MCPCB and heat sink and also to increase the surface contact conductance. Practical implications The proposed method of surface modification can be easily done at laboratory level with locally available techniques. Originality/value Much of the available literature is only concentrating on the design modification and heat transfer from fins to ambient. There was little research on modification of top surface of the heat sink and the proposed concept would give good results and also it will make the material cost reduction as well as material too.

Study of LED Thermal Resistance and TIM Evaluation Using LEDs with Built-in Sensor

Experimental Study and Taguchi Analysis on LED Cooling by Thermoelectric Cooler Integrated with Microchannel Heat Sink

Thermal Analysis and Design of High-Power LED Street Light

LED Junction Temperature Measurement: From Steady State to Transient State

A New Non-Contact Method Based on Relative Radiation Intensity for Determining Junction Temperature of LEDs

In-Situ Measurement of Junction Temperature and Light Intensity of Light Emitting Diodes with an Internal Sensor Unit

A Novel Method For On-Line Junction Temperature Measurement Of Power Modules

Analysis of thermal spreading resistance in high power LED package and its design optimization

Thermal Resistance Evaluation of High Power LED

Study on The Measurement for the Thermal Resistance of Power LED

Thermal Management for Microscale Inorganic Light-Emitting Diodes

Junction Temperature Measurement and Luminous Properties Research of High-Power LED

Analysis and Measurement of Thermal Resistance Induced by LED Bonding

Analytical investigations on the thermal properties of microscale inorganic light-emitting diodes on an orthotropic substrate

Orthogonal study and analysis of variance on a thermal management system for high-power LED package.

A Thermal Analysis of the Operation of Microscale, Inorganic Light-Emitting Diodes

Thermal Properties of Microscale Inorganic Light-Emitting Diodes in a Pulsed Operation

The Measurement of LED Junction Temperature and Thermal Capacity Using Pulse Current

Thermal resistance studies of surface modified heat sink for 3W LED using transient curve

Thermal analysis and testing of multi layer ceramic-metal packaged LED

Transient 2D Junction Temperature Distribution Measurement by Short Pulse Driving and Gated Integration with Ordinary CCD Camera