Abstract:In order to study the characteristics of fire smoke spread and temperature distribution of a large indoor pedestrian street under different heat release rates and smoke exhaust modes, this paper focuses on the analysis of fire smoke spread, visibility, smoke temperature distribution and variation curves in an atrium. This paper uses a numerical simulation method to conduct research. PyroSim fire simulation software is used to calculate this project, which is based on a full-scale experimental design scheme. The numerical simulation results show that under the conditions of higher heat release rate, the smoke spread rate is greater than that under the conditions of lower heat release rate. Furthermore, the average temperature of smoke in the atrium is also greater, up to about 400 °C. The conditions of a higher heat release rate also show the characteristics of faster generation, faster spread and a larger volume of smoke. When the smoke exhaust system is turned on, the thickness of the smoke layer and the smoke temperature decrease. There then comes a situation where the stabile section of the fire ends in advance. The simulation results of vertical temperature distribution in an atrium can fit the modified McCaffrey plume model in any case. Under all cases, the smoke temperature reaches the maximum directly above the fire source. The horizontal dimensionless smoke temperature rises under the atrium roof, and decreases exponentially with the dimensionless distance from the fire source. The greater the heat release rate of fire source is, the smaller the attenuation coefficient is, with a more than 50% change. When the smoke exhaust system is turned on, the smoke flow accelerates and the smoke is cooled rapidly. Thus, the attenuation coefficient increases. Additionally, the effect of mechanical smoke exhaust is better than natural smoke exhaust, because mechanical smoke exhaust makes air flow and heat exchange more intense. The variation amplitudes of the attenuation coefficient under natural smoke exhaust and mechanical smoke exhaust are 13% and 22%, respectively.

Simulation and Analyses of Contact Smoke Detection in Large Space Fire

The Simulation of the Sampling Pipes and Sampling Holes Network with an Aspirating Smoke Detector

Analysis of Temporal and Spatial Distribution Characteristics of Ammonium Chloride Smoke Particles in Confined Spaces

Numerical Investigation on Smoke Movement in a Large Space Building under Fire Scenarios

Numerical Investigation of Fire Smoke Transport in the Tsinghua University Sports Center

Numerical Simulation on Smoke Temperature Distribution in a Large Indoor Pedestrian Street Fire

Early fire smoke movements and detection in high large volume spaces

EXPERIMENTAL STUDY ON AIR ENTRAINMENT COEFFICIENT DURING ONE-DIMENSIONAL HORIZONTAL MOVEMENT OF FIRE-INDUCED SMOKE IN LONG CHANNELS

Numerical Simulation of the Fire Smoke Flow in the Corridor of a Building

Estimation and research of the temperature field models of large space spherical mesh shell structures under localized fire

Computational Simulation of Smoke Temperature Diffusion in High-rise Buildings Fires

An Investigation on Spill Plume Temperature of Large Space Building Fires

Temperature field distribution of large-space structures under various fire scenarios

Numerical simulation study on ventilation mode in case of corridor fire in T-shape transfer metro station

INFLUENCE ON PERFORMANCE OF SMOKE FIRE DETECTORS BY VELOCITY

Investigation on Smoke Flow in Stairwells Induced by an Adjacent Compartment Fire in High Rise Buildings

Numerical Simulation of Smoke Control in Underground Space

Numerical Study on the Airflow Characteristics and Smoke Control Condition in Stair Area of Subway Stations

Numerical simulation of smoke control modes in underground railway station fire

Sensitivity Evaluation of Smoke Fire Detectors

Numerical Simulation for Special-typed Big Fires