Abstract:In order to study the characteristics of fire smoke spread and temperature distribution of a large indoor pedestrian street under different heat release rates and smoke exhaust modes, this paper focuses on the analysis of fire smoke spread, visibility, smoke temperature distribution and variation curves in an atrium. This paper uses a numerical simulation method to conduct research. PyroSim fire simulation software is used to calculate this project, which is based on a full-scale experimental design scheme. The numerical simulation results show that under the conditions of higher heat release rate, the smoke spread rate is greater than that under the conditions of lower heat release rate. Furthermore, the average temperature of smoke in the atrium is also greater, up to about 400 °C. The conditions of a higher heat release rate also show the characteristics of faster generation, faster spread and a larger volume of smoke. When the smoke exhaust system is turned on, the thickness of the smoke layer and the smoke temperature decrease. There then comes a situation where the stabile section of the fire ends in advance. The simulation results of vertical temperature distribution in an atrium can fit the modified McCaffrey plume model in any case. Under all cases, the smoke temperature reaches the maximum directly above the fire source. The horizontal dimensionless smoke temperature rises under the atrium roof, and decreases exponentially with the dimensionless distance from the fire source. The greater the heat release rate of fire source is, the smaller the attenuation coefficient is, with a more than 50% change. When the smoke exhaust system is turned on, the smoke flow accelerates and the smoke is cooled rapidly. Thus, the attenuation coefficient increases. Additionally, the effect of mechanical smoke exhaust is better than natural smoke exhaust, because mechanical smoke exhaust makes air flow and heat exchange more intense. The variation amplitudes of the attenuation coefficient under natural smoke exhaust and mechanical smoke exhaust are 13% and 22%, respectively.

Numerical Investigation of Fire Smoke Transport in the Tsinghua University Sports Center

Numerical Investigation on Smoke Movement in a Large Space Building under Fire Scenarios

Numerical Simulation on Smoke Temperature Distribution in a Large Indoor Pedestrian Street Fire

Two Typical Phenomena from the Numerical Simulation of Fire and Smoke Transport in A Gymnasium Fire

Numerical Simulation of the Fire Smoke Flow in the Corridor of a Building

Computational Simulation of Smoke Temperature Diffusion in High-rise Buildings Fires

Numerical Study On The Performance Of Smoke Control System Of An Underground Ring Road

Application of Computer Simulation Technique in Smoke Control System Design

Numerical investigation on the effects of human movements on smoke propagation in building fire

Computational simulation of smoke temperature diffusing in high-rise building fire

Full-scale Experimental and Numerical Study of Smoke Spread and Temperature Distribution in a Room-Corridor Structure Building

3D Numerical Simulation of Smoke Flow in Long Tunnel Fires

Numerical Simulation of Smoke Movement of Subway Fire under the Effect of Piston Wind

Numerical Study on the Airflow Characteristics and Smoke Control Condition in Stair Area of Subway Stations

Sensitivity Analysis of Influencing Factors of Fire Smoke Transport on Subway Station Platforms

Simulation and Analyses of Contact Smoke Detection in Large Space Fire

Indoor Fire Simulation in Low-Rise Teaching Buildings Based on BIM–FDS

Application Attempt of Virtual Simulation in "Smoke Control and Exhaust Engineering"

Numerical Study on Smoke Temperature Characteristics in T-shaped Bifurcated Tunnel Fires

Numerical Simulation for Special-typed Big Fires

Building Fire Smoke Control Strategies Simulation Using Fire and Evacuation Information