Abstract:Thermophoretic deposition of particles in turbulent duct flow is of significant relevance in energy and thermal engineering applications. However, conjugate heat transfer (CHT) was commonly not considered in the previous studies, but may have crucial influences on particle deposition behaviors. Therefore, thermophoretic particle deposition in turbulent duct flow with and without CHT was numerically investigated by using $$\overline {v{\prime ^{_2}}} - f$$ turbulence model and discrete particle model (DPM) with a modified discrete random walk method. After grid independence study and numerical verification, several important influencing factors on particle deposition velocity were studied, such as flow Reynolds number, temperature difference between inlet hot air and cool wall, thermal conductivity ratio and width ratio of solid and fluid domain. The thermophoresis greatly increases deposition velocity of small particles but has no influence on large particles. The critical particle relaxation time $$\tau _{\rm{p}}^ + $$ for thermophoresis effect is 20, which is the same for all the cases in this study. The corresponding particle diameter is 28 µm. The thermophoretic deposition is enhanced when the flow Reynolds number and temperature difference between air and wall increase. This is because the wall-normal temperature variety is higher for large Reynolds number and temperature difference, which can enhance thermophoretic deposition. However, CHT reduces the thermophoretic deposition by decreasing temperature difference in fluid region. Besides, higher thermal conductivity ratio and width ratio of solid and fluid domain will decrease the thermophoretic deposition, as thermal conduction in solid domain becomes more intense.

Kinematic Characteristics and Thermophoretic Deposition of Inhalable Particles in Temperature Gradient Field

Kinematic Characteristics and Thermophoretic Deposition of Inhalable Particles in Turbulent Duct Flow

INVESTIGATION ON DYNAMIC CHARACTERISTICS OF INHALED PARTICLES IN TEMPERATURE FIELD

Direct numerical simulation of kinematics and thermophoretic deposition of inhalable particles in turbulent duct flows

Numerical Investigation on Thermophoretic Deposition of Particles in Turbulent Duct Flow with Conjugate Heat Transfer: Analysis of Influencing Factors

Technical study on removing inhaled PM 2.5 by using thermophoresis in annular channel with turbulent flow

Numerical investigation on monodispersed particle deposition in turbulent duct flow with thermophoresis

Study on the deposition characteristics of fine particles at local components in air conditioning ventilation ducts

Direct Numerical Simulation on Turbulent Transportation and Thermophoretic Deposition of Micron-Sized Particles in Rectangle Channel

Motion of fine particles in a temperature gradient: Experiment, visualization, and numerical simulation studies

Study on thermophoretic deposition of micron-sized aerosol particles by direct numerical simulation and experiments

Numerical analysis of particle deposition in ventilation duct

Simulation of Particles Diffusion Characteristics in the Ventilation Duct of the Air Conditioning System

Direct Numerical Simulation of Microparticle Motion in Channel Flow with Thermophoresis

Research on the deposition efficiency of nanoparticles in human airways

Particle deposition on the wall driven by turbulence, thermophoresis and particle agglomeration in channel flow

Dust Transport Investigation in Ribbed Cooling Duct Integrating Temperature-Dependent Elastic-Plastic Particle Collision Model

Fluid Flow and Heat Transfer of a Gas Stream Containing Dust Particles in a Parallel-Plates Duct

Study on particle deposition in ventilation ducts

CFD simulation of particle deposition in a horizontal turbulent duct flow

Thermophoretic Deposition of Particles in Laminar and Turbulent Tube Flows