Abstract:Two dynamical models, the traditional method of moments coupled model (MCM) and Taylor-series expansion method of moments coupled model (TECM) for particle dispersion distribution and gravitation deposition are developed in three-dimensional ventilated environments. The turbulent airflow field is modeled with the renormalization group (RNG) k–ε turbulence model. The particle number concentration distribution in a ventilated room is obtained by solving the population balance equation coupled with the airflow field. The coupled dynamical models are validated using experimental data. A good agreement between the numerical and experimental results can be achieved. Both models have a similar characteristic for the spatial distribution of particle concentration. Relative to the MCM model, the TECM model presents a more close result to the experimental data. The vortex structure existed in the air flow makes a relative large concentration difference at the center region and results in a spatial non-uniformity of concentration field. With larger inlet velocity, the mixing level of particles in the room is more uniform. In general, the new dynamical models coupled with computational fluid dynamics (CFD) in the current study provide a reasonable and accurate method for the temporal and spatial evolution of particles effected by the deposition and dispersion behaviors. In addition, two ventilation modes with different inlet velocities are proceeded to study the effect on the particle evolution. The results show that with the ceiling ventilation mode (CVM), the particles can be better mixed and the concentration level is also higher. On the contrast, with the side ceiling ventilation mode (SVM), the particle concentration has an obvious stratified distribution with a relative lower level and it makes a much better environment condition to the human exposure.

Numerical Study Of Particle Deposition In Two Differently Ventilated Rooms

Comparison of Indoor Aerosol Particle Concentration and Deposition in Different Ventilated Rooms by Numerical Method

Particle dispersion and deposition in ventilated rooms: Testing and evaluation of different Eulerian and Lagrangian models

Numerical Investigation Of Indoor Aerosol Particle Dispersion Under Stratum Ventilation And Under Displacement Ventilation

Effect of Particle Spatial Distribution on Particle Deposition in Ventilation Rooms

Particle Deposition in Indoor Environments: Analysis of Influencing Factors.

Numerical Investigation of Particle Diffusion in A Clean Room

Comparison of diffusion characteristics of aerosol particles in different ventilated rooms by numerical method

Numerical analysis of particle deposition in ventilation duct

Numerical Comparison of the Efficiency of Mixing Ventilation and Impinging Jet Ventilation for Exhaled Particle Removal in a Model Intensive Care Unit

Numerical Study of the Effect of Ventilation Pattern on Coarse, Fine, and Very Fine Particulate Matter Removal in Partitioned Indoor Environment

CFD Modeling of Particle Dispersion and Deposition Coupled with Particle Dynamical Models in a Ventilated Room

Numerical Study of the Influence of Ventilation Modes on the Distribution and Deposition of Particles Generated from a Specific Cooking Process in a Residential Kitchen

Modeling of Ultrafine Particle Dispersion in Indoor Environments with an Improved Drift Flux Model

Comparison of three simulation methods of indoor particle dispersion

Developing an Empirical Equation for Modeling Particle Deposition Velocity Onto Inclined Surfaces in Indoor Environments

Numerical Investigation of the Wall Effect on Airborne Particle Dispersion in A Test Chamber

Numerical study of the fine particle deposition behaviors on three-dimensional random rough walls

Test Of A Generalized Drift Flux Model For Simulating Indoor Particle Dispersion

Numerical Simulation on the Deposition of Nanoparticles under Laminar Conditions

Study on particle deposition in ventilation ducts