Abstract:Particle dispersion and deposition in man-made enclosed environments are closely related to the well-being of occupants. The present study developed a three-dimensional drift-flux model for particle movements in turbulent indoor airflows, and combined it into Eulerian approaches. To account for the process of particle deposition at solid boundaries, a semi-empirical deposition model was adopted in which the size-dependent deposition characteristics were well resolved. After validation against the experimental data in a scaled isothermal chamber and in a full-scale non-isothermal environmental chamber, the drift-flux model was used to investigate the deposition rates and human exposures to particles from two different sources with three typical ventilation systems: mixing ventilation (MV), displacement ventilation (DV), and under-floor air distribution (UFAD). For particles originating from the supply air, a V-shaped curve of the deposition velocity variation as a function of particle size was observed. The minimum deposition appeared at 0.1–0.5μm. For supermicron particles, the ventilation type and air exchange rate had an ignorable effect on the deposition rate. The movements of submicron particles were like tracer gases while the gravitational settling effect should be taken into account for particles larger than 2.5μm. The temporal increment of human exposure to a step-up particle release in the supply air was determined, among many factors, by the distance between the occupant and air outlet. The larger the particle size, the lower the human exposure. For particles released from an internal heat source, the concentration stratification of small particles (diameter <10μm) in the vertical direction appeared with DV and UFAD, and it was found the advantageous principle for gaseous pollutants that a relatively less-polluted occupied zone existed in DV and UFAD was also applicable to small particles.

Test Of A Generalized Drift Flux Model For Simulating Indoor Particle Dispersion

Modeling of Ultrafine Particle Dispersion in Indoor Environments with an Improved Drift Flux Model

Particle dispersion and deposition in ventilated rooms: Testing and evaluation of different Eulerian and Lagrangian models

MODELING HUMAN EXPOSURE TO PARTICLES IN INDOOR ENVIRONMENTS USING A DRIFT-FLUX MODEL

Modeling And Simulation Of Particle Dispersion In Dense Particle-Laden Flow

Developing an Empirical Equation for Modeling Particle Deposition Velocity Onto Inclined Surfaces in Indoor Environments

Numerical Prediction of Indoor Airborne Particle Concentration in a Test Chamber with Drift-Flux Model

Modeling particle dispersion and deposition in indoor environments

Numerical Study Of Particle Deposition In Two Differently Ventilated Rooms

CFD Modeling of Particle Dispersion and Deposition Coupled with Particle Dynamical Models in a Ventilated Room

Comparison of three simulation methods of indoor particle dispersion

CFD Modeling of Aerosol Transport and Deposition Using a Drift-Flux Model

Construction and Validation of an Urban Area Flow and Dispersion Model on Building Scales

Numerical Investigation of Particle Diffusion in A Clean Room

Improved model for simulating indoor suspended particles

Particle Deposition in Indoor Environments: Analysis of Influencing Factors.

Numerical Investigation of the Wall Effect on Airborne Particle Dispersion in A Test Chamber

Wind Tunnel and Numerical Study of Outdoor Particle Dispersion Around a Low-Rise Building Model

Simulation Methods of Indoor Particles Dispersion and Distribution

Dispersion of cylindrical particles in turbulent flows

Study on the Impacts of Human Walking on Indoor Particles Dispersion Using Momentum Theory Method