Abstract:Modeling the behavior of suspended particles in gaseous phase is important for diverse reasons; e.g. aerosol is usually the main subject of CFD simulations in clean rooms. Additionally, to determine the rate and sites of deposition of particles suspended in inhaled air, the motion of the particles should be predicted in lung airways. Meanwhile there are two basically different approaches to simulate the behavior of particles suspension, Lagrangian and Eulerian approaches. This study compares the results of these two approaches on simulating the same problem. An in-house particle tracking code was developed to simulate the motion of particles with Lagrangian approach. In order to simulate the same problem with Eulerian approach, the solution to the transport equation with appropriate initial and boundary conditions was used. In the first case study, diffusion of particles, initially positioned homogeneously on an infinite plane was modeled with both approaches and the results were compared and the mismatch between Lagrangian and Eulerian approaches was analyzed for different concentrations. In the second case study, airflow with parabolic velocity profile moving between two parallel plates was modeled with two approaches. The airflow initially contained a homogeneous suspension of particles and the plates were maintained at zero concentration. The concentration along the plates was compared between the two approaches and the differences in the performance of each approach were investigated, again for different initial concentrations. The overall results confirm that as particle concentration falls below a minimum amount, approximately 105 m−2, the results of the two approaches deviate considerably from each other and hence the Eulerian approach cannot be taken as an alternative for Lagrangian approach for low concentrations. For the third problem, we investigated the 3D particle flow in an expanding lung alveolus. It is shown that when the number of total released particles increases, the results of Eulerian approach can be used as an alternative to Lagrangian simulation. Since the number of particles existing in the lung alveolus in normal condition is much lower than this value, we concluded that Eulerian method cannot be applied to problems involving low concentration of particles. Although, the results of the Lagrangian problem may converge to the Eulerian one by increasing simulation time, but it is a hypothetical situation which not really exist in short time scale problems such as third case study in this paper.

Particle dispersion and deposition in ventilated rooms: Testing and evaluation of different Eulerian and Lagrangian models

Numerical Study Of Particle Deposition In Two Differently Ventilated Rooms

Comparison of three simulation methods of indoor particle dispersion

Advances in Cryogenic Engineering: Volumes 35A and B

CFD Modeling of Particle Dispersion and Deposition Coupled with Particle Dynamical Models in a Ventilated Room

Test Of A Generalized Drift Flux Model For Simulating Indoor Particle Dispersion

Comparison of Indoor Aerosol Particle Concentration and Deposition in Different Ventilated Rooms by Numerical Method

Numerical Investigation Of Indoor Aerosol Particle Dispersion Under Stratum Ventilation And Under Displacement Ventilation

Modeling of Ultrafine Particle Dispersion in Indoor Environments with an Improved Drift Flux Model

Developing an Empirical Equation for Modeling Particle Deposition Velocity Onto Inclined Surfaces in Indoor Environments

Particle Deposition in Indoor Environments: Analysis of Influencing Factors.

Using Large Eddy Simulation to Study Particle Motions in a Room

Numerical Investigation of Particle Diffusion in A Clean Room

Effect of Particle Spatial Distribution on Particle Deposition in Ventilation Rooms

Modeling particle deposition from fully developed turbulent flow in ventilation duct

Numerical Study of the Influence of Ventilation Modes on the Distribution and Deposition of Particles Generated from a Specific Cooking Process in a Residential Kitchen

Numerical Study of the Effect of Ventilation Pattern on Coarse, Fine, and Very Fine Particulate Matter Removal in Partitioned Indoor Environment

CFD simulation of particle deposition in a horizontal turbulent duct flow

Particle deposition in turbulent duct flows—comparisons of different model predictions

Modeling Particle Dispersion in Personalized Ventilated Room

Modeling particle deposition onto rough walls in ventilation duct