Abstract:We designed a thermal precipitator in a cylindrical configuration with a size-selective inlet, and investigated its performance in experiments using differential mobility analyzer (DMA)-classified particles of sodium chloride (NaCl) and polystyrene latex (PSL). Our investigation was performed in two parts: (1) using the size-selective inlet to determine the best inlet-to-wall distance for optimal impaction of 1 μm particles; (2) using a simple inlet tube to measure particle collection via thermophoresis over a size range from 40 nm to 1000 nm. The results showed that the inlet had a particle cut-off curve, with a 50% particle cut-off Stokes number of 0.238, resulting in removing particles with sizes larger than 1 μm at an aerosol flow rate of 1.5 lpm. The thermophoretic particle collection efficiency in the prototype was measured without the size-selective inlet installed. The size dependence of the collection efficiency was negligible for particles with diameters ≤300 nm and became noticeable for those with diameters >300 nm. An analytical model was further developed to estimate the particle collection efficiency due to thermophoresis of the prototype under various aerosol flow rates and temperature gradients. For particles with diameters less than 400 nm, reasonable agreement was obtained between the measured data and the collection efficiency calculated from the developed analytical model. It was further concluded that the derived formula for the calculation of thermophoretic particle collection efficiency could serve as the backbone for future design of thermal precipitators in any configuration, when combined with the proper formula for the dimensionless thermophoretic particle velocity. Copyright 2012 American Association for Aerosol Research

INVESTIGATION ON DYNAMIC CHARACTERISTICS OF INHALED PARTICLES IN TEMPERATURE FIELD

Kinematic Characteristics and Thermophoretic Deposition of Inhalable Particles in Temperature Gradient Field

Kinematic Characteristics and Thermophoretic Deposition of Inhalable Particles in Turbulent Duct Flow

Experimental Study of the Effect of Inclination Angle on the Minimum Conveying Velocity and the Underlying Mechanisms

Technical study on removing inhaled PM 2.5 by using thermophoresis in annular channel with turbulent flow

Direct numerical simulation of kinematics and thermophoretic deposition of inhalable particles in turbulent duct flows

Direct Numerical Simulation of Microparticle Motion in Channel Flow with Thermophoresis

Motion of fine particles in a temperature gradient: Experiment, visualization, and numerical simulation studies

EXPERIMENTAL STUDY ON AIR ENTRAINMENT COEFFICIENT DURING ONE-DIMENSIONAL HORIZONTAL MOVEMENT OF FIRE-INDUCED SMOKE IN LONG CHANNELS

Research on the deposition efficiency of nanoparticles in human airways

Experimental Study on the Thermophoresis Movement of Submicron Particle in the Boundary Layer of the Rectangular Pipe

Inhalable Particle Behaviors In Laminar Flows Around Triangular And Circular Cylinders

INVESTIGATION ON PARTICLES' PREFERENTIAL CONCENTRATION IN GAS-PARTICLE TURBULENT FLOW

Numerical Study of the Effect of Ventilation Pattern on Coarse, Fine, and Very Fine Particulate Matter Removal in Partitioned Indoor Environment

Numerical Investigation of the Wall Effect on Airborne Particle Dispersion in A Test Chamber

Experimental Study of Gas-Particle Two-Phase Flows with Temperature Differences

Study on thermophoretic deposition of micron-sized aerosol particles by direct numerical simulation and experiments

Particle deposition on the wall driven by turbulence, thermophoresis and particle agglomeration in channel flow

A Cylindrical Thermal Precipitator with A Particle Size-Selective Inlet

Numerical Study Of Particle Deposition In Two Differently Ventilated Rooms

Experimental investigation of interparticle collision rate in particulate flow