Abstract:The objective of this paper is to determine how the high-voltage discharging metal vapour deposited on the nearby ceramic inner surface influences the breakdowns of gaps between centre shield and end shield in vacuum interrupters. Two types of shield materials were selected, namely copper and stainless steel. The end curvature radius of the shield was 3 mm. The distance between the shields could adjust manually from 4 to 8 mm. The distance between the shields and ceramic was 3.5 mm. The negative polarity standard lightning impulse voltage (12/50 μs) was repeated for 900 operations based on an up-and-down method. The experimental results illustrated that the metal deposition layer on the inner surface of the ceramic envelope significantly influenced the breakdown voltage of the shield gaps. At a shield gap distance of d = 4 mm, the breakdown voltage of the shield gap increased from an initial lower voltage to the saturation voltage by approximately 200 operations. Then, the breakdown voltage decreased to a lower voltage range during only 50 operations, and the breakdown voltage maintained at this lower voltage range until the end of 900 operations. Furthermore, as the shield gap distance increased from d = 4 to 6 mm and 8 mm, the breakdown voltage also maintained at this lower voltage range. A metal deposition layer was formed on the inner surface of ceramic by repetitive application of the lightning impulse voltage. To analyse the influence of the metal deposition layer, the electric field distributions were calculated for the original vacuum interrupter and the vacuum interrupter with the metal deposition layer on the ceramic inner surface. The simulation results suggested that the metal deposition layer took part in the breakdown path between the shield gaps and deteriorated the insulation performance.

Experimental Research of Triggering Characteristics of the Surface Breakdown Type Triggered Vacuum Switch

Design and Performance Analysis of Multi-gap Multi-channel Spark Switch with LCR Triggered Method

Research on the trigger process of surface flashover triggered vacuum switch

A Triggered Spark-Gap Switch for High-Repetition Rate High-Voltage Pulse Generation

Long Lifetime, Triggered, Spark-Gap Switch For Repetitive Pulsed Power Applications

Research on Conduction Delay Time Characteristics of Double-Gap Surface Flashover Triggered Multistage Vacuum Switch

Closing mechanism of electrically-triggered vacuum surface flashover switch

Influence of Trigger Pulse on the Trigger Characteristics of Surface Flashover Trigger Vacuum Switch

Trigger voltage walk-in effect of ESD protection device in HVCMOS

Comparative Study of Pulsed Breakdown Processes and Mechanisms in Self-Triggered Four-Electrode Pre-Ionized Switches

Investigation of the Trigger Voltage Walk-In Effect in Ldmos for High- Voltage Esd Protection

Experimental Research of ZnO Surface Flashover Trigger Device of Pseudo-Spark Switch

A Three-Electrode Gas Switch Triggered by Microhollow Cathode Discharge with Low Trigger Voltage

Breakdown of shield gaps in vacuum interrupters

A Low-Jitter Self-Triggered Spark-Discharge Pre-Ionization Switch: Primary Research on Its Breakdown Characteristics and Working Mechanisms

Surface Flashover of Alumina Ceramic Insulators in Vacuum

Numerical Modeling of Different Streamer Breakdown Modes of Gas Switch under the External Circuit

Impact of overvoltage on the mode transition of the spark gap switch: from edge breakdown to stochastic breakdown

Investigation on Breakdown Characteristics of a Pulsed Gas Switch and Influence of Pre-Ionization

Key factors affecting trigger voltage of SCRS for ESD protection

Development of P-C Switch with Adjustable Gap