Abstract:Compositely doped oxide La0.7Sr0.3Co0.3Fe0.7O3 (LSCF) was synthesized using solid state reaction and citric acid-nitrate low temperature self-propagating combustion methods. The crystal structure and the particle size micrograph of LSCF powders synthesized by different methods were investigated with XRD and SEM. The experimental results show that the single perovskites phase of LSCF can be synthesized by both methods. The particle size of LSCF by citric acid-nitrate low temperature self-propagating combustion method was the smaller. Two types of cathodes wafers were fabricated with the two kinds of LSCF powders and Ce0.9Gd0.1O1.95 (GDC) at the mass rate of 6:4, respectively. The electrical conductivity of sintered samples was measured by four probe DC method from 100 degrees C-800 degrees C. The cathode with LSCF particle by citric acid-nitrate low temperature self-propagating combustion method has the higher electrical conductivity. The conduction mechanism for the samples is attributable to the adiabatic-hopping of p-type small polaron. In order to investigate the stability, the samples were put into the muffle furnace to heat up in air at 800 degrees C for 800h. To analyze the reason for reduced electrical conductivity, the crystal structure and the particle micrograph of the cathodes before and after exposure were investigated with XRD and SEM. The result shows that both cathodes have good stability, good compatibility with GDC. The sample micrographs do not change too much. The electrical conductivity of the two cathodes reduces a little after exposure.

Facile Autocombustion Synthesis of La0.6Sr0.4Co0.2Fe0.8O3−δ (LSCF) Perovskite Via a Modified Complexing Sol–gel Process with NH4NO3 As Combustion Aid

Low-temperature Solid Oxide Fuel Cells with Novel La0.6Sr0.4Co0.8Cu0.2O3−δ Perovskite Cathode and Functional Graded Anode

Facile Auto-Combustion Synthesis for Oxygen Separation Membrane Application

Effect of HNO3 treatment on the La0.6Sr0.4Co0.2Fe0.8O3-delta obtained via combined EDTA-citrate complexing process

Effect of HNO3 treatment on the La0.6Sr0.4Co0.2 Fe0.8O3-δ obtained via combined EDTA-citrate complexing process

Effect of HNO_3 Treatment on the La_(0.6)Sr_(0.4)Co_(0.2)Fe_(0.8)O_(3-δ) Obtained via Combined EDTA-citrate Complexing Process

LSCF Nanopowder from Cellulose–Glycine-Nitrate Process and its Application in Intermediate-Temperature Solid-Oxide Fuel Cells

Characterization And Stability Of La0.7sr0.3co0.3fe0.7o3 Perovskite-Type Oxide

Preparation, Structure and Performance of La0.6Sr0.4Co0.2Fe0.8O3 Cathodes of Intermediate Temperature Solid Oxide Fuel Cells

A new (La0.2Nd0.2Gd0.2Sr0.2Ba0.2)Co0.2Fe0.8O3-δ high-entropy oxide cathode for intermediate temperature solid oxide fuel cell

Auto-combustion synthesis of nanocrystalline LaFeO3

Enhancement of the electrochemical properties for La0.6Sr0.4Co0.2Fe0.8O3−δ oxygen electrode by the addition of CaxCo4O9+δ nano-catalysts

Enhancement of the electrocatalytic activity of La0.6Sr0.4Co0.2Fe0.8O3-δ through surface modification by acid etching

Preparation of a nano-size (La0.2Nd0.2Sm0.2Sr0.2Ba0.2)Co0.2Fe0.8O3-δ/SDC high-entropy oxide composite cathode

Synthesis of SmBaCo2O6−δ powder by the combustion process using Co3O4 as precursor

Synthesis And Electrical Properties Of La0.6m0.4feo3-Delta (M=Ca, Sr, Ba) As Cathodes For Sofcs

High performance La2NiO4+δ impregnated La0.6Sr0.4Co0.2Fe0.8O3-δ cathodes for solid oxide fuel cells

A Novel Route to Synthesize Nano-Crystalline Ba0.5sr0.5co0.8fe0.2o3-Delta Perovskite Oxide at High Temperature

Preparation of La-0.Sr-9(0).Ga-1(0).Mg-8(0).O-2(2).(85) ultrafine powder by low temperature combustion synthesis

Functional nano-composite oxides synthesized by environmental-friendly auto-combustion within a micro-bioreactor

Preparation of Sr 2Fe 1-xSc xMoO 6-δ nanopowders and its electrical conductivity