Abstract:La 0.6Sr 0.4-xCa xCo 0.2Fe 0.8O 3 (LSCCF) powders were prepared from relative oxides and carbonate powders by a gel-casting process. Phase structure of the obtained powders with different calcium dosages (x = 0.0, 0.2, 0.4) was investigated. Density and porosity of the sintered LSCCF samples were measured by the Archimedes method. Microstructure was observed by scanning electron microscope (SEM) and electrical conductivity of the specimens was tested using the four-probe method. Effects of calcium dosage on the thermal expansion coefficient (TEC) of the sintered LSCCF samples were also studied. The results showed that superfine and well-dispersed LSCCF powders with perovskite structure were obtained when the dried gels were calcined at temperature above 1000 °C. The calcium dosage and sintering temperature have an obvious influence on the density and pore characteristics of the LSCCF samples. Open porosities of LSCCF samples sintered at different temperature vary from 4.7% to 50.2%, decreasing as calcium dosage and sintering temperature increase. Thermal expansion coefficients of the LSCCF materials also greatly depend on calcium dosage. A typical TEC value of 13.05 × 10 -6 K -1 for La 0.6Sr 0.2Ca 0.2Co 0.2Fe 0.8O 3 samples was obtained at 800 °C, lower than values obtained for samples with no calcium dosage. Electrical conductivity of the LSCCF samples decreases as calcium dosage increases, but all samples showed a conductivity value above 300 S cm -1 at 400-800 °C, which can satisfy the requirements of cathode materials for solid oxide fuel cells. © 2012 Elsevier B.V.

Synthesis And Electrical Properties Of La0.6m0.4feo3-Delta (M=Ca, Sr, Ba) As Cathodes For Sofcs

Low-temperature Solid Oxide Fuel Cells with Novel La0.6Sr0.4Co0.8Cu0.2O3−δ Perovskite Cathode and Functional Graded Anode

Electrode redox properties of Ba 1−x La x FeO 3−δ as cobalt free cathode materials for intermediate-temperature SOFCs

Preparation And Characterization Of Ba0.4sr0.6co1-Xfexo3-Delta Cathode Materials

Characterization And Properties Of La1-Xsrxfeo3-Delta With Perovskite-Type Structure

Characterization And Stability Of La0.7sr0.3co0.3fe0.7o3 Perovskite-Type Oxide

Thermal, Electrical, and Electrochemical Properties of Lanthanum-doped Ba0.5Sr0.5 Co0.8Fe0.2O3–δ

Synthesis And Characterization Of La1-Xcaxfeo3-Delta For Cathodes By Gnp Method

XRD, XANES, and Electrical Conductivity Analysis of La- and Zr-Doped Ba0.5Sr0.5Fe0.9Cu0.1O3-δ Suitable for IT-SOFC Cathodes

Synthesis and characterization of fibrous La0.8Sr0.2Fe1-xCuxO3-δ cathode for intermediate-temperature solid oxide fuel cells

Electrochemical Properties of La0.8sr0.2ga0.8mg0.2o2.8 Electrolyte and Its Application to Sofcs

A Comparative Study of Oxygen Reduction Reaction on Bi- and La-Doped SrFeO[sub 3−δ] Perovskite Cathodes

Synthesis, Structural, Electrical and Microchemistry Properties of Novel (LSCFM) LaxSr1-xCo1-y-zFeyMnzO3-δ (x=0.4, 0.6, 0.8, y=0.4, 0.8 and z=0.1, 0.2) Perovskites for SOFC Applications

Enhanced Performance of La<sub>0.8</sub>Sr<sub>0.2</sub>FeO<sub>3-</sub>-Gd<sub>0.2</sub>Ce<sub >0.8</sub>O<sub>2-</sub> Cathode for Solid Oxide Fuel Cells by Surface Modification with BaCO<sub>3</sub> Nanoparticles

La0.4Bi0.4Sr0.2FeO3-δ As Cobalt-free Cathode for Intermediate-Temperature Solid Oxide Fuel Cell

Preparation And Characterization Of Graded Cathode La0.6sr0.4co0.2fe0.8o3-Delta

Optimization on Fabrication and Performance of A-site-deficient La 0.58 Sr 0.4 Co 0.2 Fe 0.8 O 3-Δ Cathode for SOFC

Synthesis and characterization of La 0.6Sr 0.4-xCa xCo 0.2Fe 0.8O 3 materials by the gel-casting process

Characterization of Cation-Ordered Perovskite Oxide LaBaCo2O5+δ As Cathode of Intermediate-Temperature Solid Oxide Fuel Cells

Preparation and Properties of Fe-Based Double Perovskite Oxide as Cathode Material for Intermediate-Temperature Solid Oxide Fuel Cell

Electrochemical properties of La 0.8 Sr 0.2 FeO 3 − δ –La 0.45 Ce 0.55 O 2 − δ composite cathodes for intermediate temperature SOFC