Abstract:The effect of annealing temperature (T a = 200, 250, and 300 °C) on the structural properties, ac conductivity, and complex dielectric constants ( and ) of indium-doped tin oxide (ITO) thin films (~ 90 nm thick)/0.5 mm boro-float substrates (BFS) synthesized by radio frequency (RF) sputtering is investigated. The X-ray diffraction (XRD) examination demonstrated that indium was successfully substituted with tin atoms to form ITO films and the crystallite size for the cubic phase, as well as particle size, were impacted by T a . The real part of complex dielectric constants ( ) was significantly reduced for all ITO/BFS from the range of 2.7 × 10 4 –5.1 × 10 4 to 5.3–19 as the frequency ( f ) was increased to 0.25 Hz, while it remained constant for further increases in f . The value of for the as-prepared ITO/BFS was increased as T a increased up to 250 °C, then was decreased at T a =300 °C. A similar finding was detected for the loss factor with no observation of any relaxation peaks. The Q-factor was increased for all ITO/BFS as f increased to 100 Hz and then was reduced with increasing f up to 20 MHz, while steadily increasing with T a . The deduced frequency exponent is greater than 0.5 for the ITO/BFS, indicating their electronic conduction nature. The density of the localized states and hopping frequency of the ITO/BFS were increased by annealing at 200 °C, meanwhile was decreased for T a = 300 °C. The binding energy was decreased from 0.647 eV for the as-prepared ITO/BFS to 0.518 eV by annealing at 200 °C, meanwhile was increased to 0.74 and 0.863 eV for T a equals 250, and 300 °C, respectively. The Cole-Cole plots revealed a single semicircular arc for all films, and their corresponding equivalent circuit was analyzed. The equivalent bulk resistance was gradually decreased by annealing in the range of 200–300 °C, whereas the equivalent capacitance was increased. The resistance of grains and resistance of grain boundaries of the as-prepared ITO/BFS was gradually decreased by increasing T a to 250 °C, while it was increased for T a = 300 °C. These outcomes recommended the RF sputtered ITO/BFS for high-frequency devices, integrated circuits, and supercapacitors.

Annealing Effect on ITO Films Prepared by DC Magnetron Sputtering

The Effects Of Annealing On Characteristics Of The Ito Films

Influence of Thermal Annealing on Electrical and Optical Properties of Indium Tin Oxide Thin Films

Effects on Heat Treatment Methods in Indium-Tin-Oxide Films by DC Magnetron Sputter of Powder Target

Correlation between microstructure and electrical, optical properties of thermal annealed ITO thin films

Influence of annealing on microstructure and electrochromic properties of WO3 thin film

Annealing effects on properties of antimony tin oxide thin films deposited by RF reactive magnetron sputtering

Annealing effects of In2O3 thin films on electrical properties and application in thin film transistors

Effects of processing parameters on crystalline structure and optoelectronic behavior of DC sputtered ITO thin film

The key of ITO films with high transparency and conductivity: Grain size and surface chemical composition

The Main Role of Thermal Annealing in Controlling the Structural and Optical Properties of ITO Thin Film Layer

Characterization of nanocrystalline indium tin oxide thin films prepared by ion beam sputter deposition method

Effects of annealing temperature on the structural, morphology, optical properties and resistivity of sputtered CCTO thin film

Optical and electrical properties of ITO film on flexible fluorphlogopite substrate

Role of the annealing parameters on the resistance of indium tin oxide nanocrystalline films

Effect of annealing temperature on the structure and dielectric characterization of ITO thin films on a boro-float substrate prepared by radio frequency sputtering

Effects of the Variations of Oxide Structure on the Electrical and Optical Properties of ITO Films

Growth and Annealing of High Mobility Transparent Conductive Tungsten-Doped Indium Oxide Films

Influence of annealing temperature in ITO thin films prepared by Thermionic Vacuum Arc (TVA) Technique

Effects of Annealing Process on Characteristics of Fully Transparent Zinc Tin Oxide Thin-Film Transistor

Effect of Annealing on the Structural, Magnetic, Surface Energy and Optical Properties of Co32Fe30W38 Films Deposited by Direct-Current Magnetron Sputtering