Influence of annealing temperature on electro-optical and microstructural characteristics of designed In2O3/Ag/TiO2 films with applicability in optoelectronic devices
Shakiba Sharifian Manesh,Mohsen Ghasemi,Gholamhosain Haidari
DOI: https://doi.org/10.1007/s10854-022-07743-7
2022-01-27
Abstract:In the present paper, the In2O3/Ag/TiO2 (IAT)-nanostructured transparent conductive multilayer system was designed and simulated. The optimal thickness of each layer has been calculated to have both high optical transmission and low electrical resistance simultaneously. The IAT-nanostructured films were deposited on the glass substrate using thermal evaporation. Then, they were annealed at a temperature of 100, 150, 200, 300, and 400 °C for 90 min so that the required transparent layers could be obtained. The effects of annealing temperature on the electrical, microstructural, and optical properties of the multilayer film, including sheet resistance, crystallite size, strain, surface morphology, optical transmission, reflection, and energy band gap, were investigated. The results show that the annealing temperature of 150 °C was considered as the optimum annealing temperature because the highest average transmission in the visible region (79.25%), the lowest sheet resistance (2.4 Ω/sq), and the maximum figure of merit (1.80 × 10−1 (Ω-1documentclass[12pt]{minimal}usepackage{amsmath}usepackage{wasysym}usepackage{amsfonts}usepackage{amssymb}usepackage{amsbsy}usepackage{mathrsfs}usepackage{upgreek}setlength{oddsidemargin}{-69pt}egin{document}$${Omega }^{-1}$$end{document})) for the IAT structure were obtained at this temperature. The correlation between the electrical, microstructural, and optical properties of these layers is investigated. As an application for the prepared IAT films, an inverted polymer photovoltaic cell was fabricated. The results show that photovoltaic cells fabricated with the IAT multilayer system have higher power conversion efficiency than those fabricated with commercially available ITO films. According to the suitable electro-optical properties of the IAT multilayer at the optimal temperature of 150 °C, this structure can be a good alternative for the common ITO electrodes.
engineering, electrical & electronic,materials science, multidisciplinary,physics, condensed matter, applied