Abstract:The insulation condition is the key to determining whether gas insulated switchgears (GISs) can operate stably and reliably. Partial discharge (PD) detection is an important technique for condition monitoring and evaluation in GIS. Acoustic emission (AE) method is commonly used in on-site PD detection. However, in field applications, there are often problems such as low signal-to-noise ratio (SNR) of measured ultrasonic signals and difficulty in extracting PD pulses. To solve this problem, a denoising method for GIS ultrasonic signals based on the combination of ultrasonic and ultra-high frequency (UHF) signals is proposed in this paper. Based on the difference in correlation between noise and PD signals, the noise in measured signal can be suppressed through accumulating and averaging of multiple ultrasonic signals, and the SNR of PD signal can be significantly improved. An actual 500-kV GIS experiment platform is established, and PD measurements for different types of defects are conducted. Then, a comparative study is conducted on the denoising performance of the proposed method and traditional denoising methods such as wavelet method and singular value decomposition (SVD) method. The results indicate that compared to traditional methods, the method proposed in this paper has a higher reduction in noise level. Especially for extremely low-SNR signals (PD pulses buried in noise), traditional methods have poor performance, while the proposed method can still extract the PD pulse form the noise. Furthermore, based on the denoised ultrasonic signals, the defect localization analysis is conducted to demonstrates the correctness of the denoising results. Finally, the proposed method is applied to on-site PD detection, which further evaluates the effectiveness of the denoising method.

Monitoring Techniques for Ultra-High-Frequency Partial Discharge Signal in Narrow-Band

Detection and Identification Technologies of Wide Band Partial Discharge

APPLICATION OF FREQUENCY MIXING TECHNIQUE TO ULTRA-HIGH-FREQUENCY PD DETECTION FOR TRANSFORMERS

Partial Discharge Wideband Full-Band High-Gain Resonant Cavity UHF Sensor Research

Signal Processing Technique for On-Line Partial Discharge Monitoring of Power Transformers

Research on Miniaturized UHF Sensing Technology for PD Detection in Power Equipment Based on Symmetric Cut Theory

Application of HFCT and UHF Sensors in On-Line Partial Discharge Measurements for Insulation Diagnosis of High Voltage Equipment

Location of PD by Searching in Space Using UHF Method

The Frequency Range Selection for Measurement of Partial Discharge in Transformer Oil with UHF Method and Interference Suppression

Evaluation of the UHF Method Based on the Investigation of a Partial Discharge Case in Post Insulators

Experimental Investigation on High Frequency Sensing Characteristis of Floating Type Partial Discharge

Comparison of Different Time-Frequency Analysis Methods for Sparse Representation of PD-induced UHF Signal

Finding Ways to Effectively Use Year 12 Achievement Data to Inform Practice in Secondary Schools.

Research on the Calibration Methods for Ultra-high Frequency Partial Discharge Detector

A Denoising Method for Partial Discharge Ultrasonic Signals in GIS Based on Ultra-High Frequency Signal Synchronization

Design and Implementation of Ultra-Wide Band Antenna for Partial Discharge Detection in High Voltage Power Equipment

Time–frequency characteristics of abnormal waveshapes in PD pulse sequence using ultra-wideband detection

Blind source separation method for multi-source ultra-high frequency partial discharge signals

Field test on a transformer for partial discharge location by uwb-rf method

Research on the Typical Partial Discharge Using the UHF Detection Method for GIS

Investigation of the UHF Partial Discharge Detection Characteristics of a Novel Bushing Tap Sensor for Transformers