Abstract:The insulation condition is the key to determining whether gas insulated switchgears (GISs) can operate stably and reliably. Partial discharge (PD) detection is an important technique for condition monitoring and evaluation in GIS. Acoustic emission (AE) method is commonly used in on-site PD detection. However, in field applications, there are often problems such as low signal-to-noise ratio (SNR) of measured ultrasonic signals and difficulty in extracting PD pulses. To solve this problem, a denoising method for GIS ultrasonic signals based on the combination of ultrasonic and ultra-high frequency (UHF) signals is proposed in this paper. Based on the difference in correlation between noise and PD signals, the noise in measured signal can be suppressed through accumulating and averaging of multiple ultrasonic signals, and the SNR of PD signal can be significantly improved. An actual 500-kV GIS experiment platform is established, and PD measurements for different types of defects are conducted. Then, a comparative study is conducted on the denoising performance of the proposed method and traditional denoising methods such as wavelet method and singular value decomposition (SVD) method. The results indicate that compared to traditional methods, the method proposed in this paper has a higher reduction in noise level. Especially for extremely low-SNR signals (PD pulses buried in noise), traditional methods have poor performance, while the proposed method can still extract the PD pulse form the noise. Furthermore, based on the denoised ultrasonic signals, the defect localization analysis is conducted to demonstrates the correctness of the denoising results. Finally, the proposed method is applied to on-site PD detection, which further evaluates the effectiveness of the denoising method.

Comparison of Different Time-Frequency Analysis Methods for Sparse Representation of PD-induced UHF Signal

Time–frequency Analysis of PD-induced UHF Signal in GIS and Feature Extraction Using Invariant Moments

Relationship Between Time-Frequency Representation of PD-induced UHF Signal and PD Current Pulse

Discrimination of Three or More Partial Discharge Sources by Multi-Step Clustering of Cumulative Energy Features

Research on the Typical Partial Discharge Using the UHF Detection Method for GIS

Propogation Characteristics of PD‐induced UHF Signal in 126 Kv GIS with Three‐phase Construction Based on Time–frequency Analysis

A Denoising Method for Partial Discharge Ultrasonic Signals in GIS Based on Ultra-High Frequency Signal Synchronization

Uhf Signal Processing and Pattern Recognition of Partial Discharge in Gas-Insulated Switchgear Using Chromatic Methodology

Chromatic Processing for Feature Extraction of PD-induced UHF Signals in GIS

Location of PD by Searching in Space Using UHF Method

Time–frequency characteristics of abnormal waveshapes in PD pulse sequence using ultra-wideband detection

Investigation of Frequency Characteristics of Typical PD and the Propagation Properties in GIS

Blind source separation method for multi-source ultra-high frequency partial discharge signals

Analysis Of The Intrinsic Characteristics Of The Partial Discharge Induced By Typical Defects In Gis

Investigation on the Sensitivity of the UHF Method for Partial Discharge Detection in GIS

Time-Frequency Analysis on Pulse Current of Partial Discharge by Adaptive Spectrogram

An Automatic Tool for Partial Discharge De-Noising via Short-Time Fourier Transform and Matrix Factorization

Extracting Partial Discharge Signals Using AGR

Evaluation of the UHF Method Based on the Investigation of a Partial Discharge Case in Post Insulators

Investigation of the Evaluation of the Pd Severity and Verification of the Sensitivity of Partial-Discharge Detection Using the Uhf Method in Gis

Segmented Spectrum Energy Characteristics-based Density Clustering of Partial Discharge Signals