Abstract:The hot deformation behaviors of Fe–28Mn–10Al–1.5C–0.6V steel at T = 950–1150 °C and = 0.01–10 s −1 were studied using the Gleeble-3500 thermo-mechanical simulator. The constitutive model of Fe–28Mn–10Al–1.5C–0.6V steel was established by an artificial neural network (ANN) based on the experimental flow stress data. The critical conditions of dynamic recrystallization (DRX) of the steel under experimental conditions were studied by using both the Najafizadeh–Jonas work hardening rate model and the Cingara–McQueen rheological stress model. The true stress–true strain curve of the steel was analyzed, the work hardening rate was calculated, and the critical strain model was established. At the same time, the relevant material parameters were calculated by linear regression, and the DRX kinetics model of JMAK was also established. This model then was combined with the finite element software DEFORM-3D to simulate the DRX behavior of the steel during hot deformation. These results indicated that the rheological stress of Fe–28Mn–10Al–1.5C–0.6V steel at low shows higher temperature sensitivity and that high T and low are conducive to the occurrence of DRX. The average relative error of the ANN constitutive model is 2.40%, which has high prediction accuracy. The dynamic recrystallization conditions determined by the above models are reliable and conform to the experimental rules. By verifying the microstructure of the steel after thermal compression, the prediction error of the finite element model to the DRX volume fraction is mostly within 10%. Thus, the model has a good predictive ability and provides an effective tool for predicting plastic deformation and microstructure in industrial production.

Research on the Dynamic Recrystallization Behavior of 20SiMn

Experimental Research on Mathematical Model of Dynamic Recrystallization for 60Si2Mn Steel

Research on Dynamic Recrystallization Behavior of 30Cr2Ni4MoV Rotor Steel

Dynamic Recrystallization Behavior and Constitutive Modeling of As-Cast 30cr2ni4mov Steel Based on Flow Curves

Research on Dynamic Recrystallization of the Microalloyed Forging Steels

Dynamic Recrystallization Behavior of Microalloyed Forged Steel

Study on dynamic recrystallization of ultra-high strength 22MnB5 steel during hot rolling

Microstructure simulation and experiment investigation of dynamic recrystallization for ultra high strength steel during hot forging

Modelling of Dynamic Recrystallization in Hot Working

Modeling of Dynamic Recrystallization and Flow Stress of Nb‐Bearing Steels

Mathematical modeling for dynamic recrystallization behavior of 40Cr steel

Investigation on Dynamic Recrystallization Behavior of Martensitic Stainless Steel

Dynamic Recrystallization Critical Conditions and a Physically–Based Constitutive Model of Al–4.8Mg Alloy Under Hot Working Conditions

Research on flow stress model and dynamic recrystallization model of X12CrMoWVNbN10-1-1 steel

Research on hot deformation, dynamic recrystallization and numerical simulation of Fe–28Mn–10Al–1.5C–0.6V steel

Modeling of Dynamic Recrystallization Kinetics of a High Strength Low Alloy Steel During Hot Rolling

Investigation of Constitutive Relationship and Dynamic Recrystallization Behavior of 22mnb5 During Hot Deformation

NUMERICAL SIMULATION OF DYNAMIC DECRYSTALLIZATION DURING HOT FORGING

Current Research Status of Dynamic Recrystallization Model of Metallic Materials

Modeling of Dynamic Recrystallization Evolution for Cr8 Alloy Steel and Its Application in FEM

Characterization and Calculation of the Dynamic Recrystallization Texture in Fe-3.0 Wt.% Si Alloy