Abstract:The gas-solid vertical single helical ribbon agitated reactor is widely used in the polypropylene industry. The gas flow and mass transfer determine the heat transfer capacity and product quality. In this work, the pressure drop was measured below and above minimum fluidization velocity (umf). Then, the axial and radial dispersion coefficients (DL and DR) were estimated below umf by measuring the step residence time distribution and the stationary radial tracer profiles, respectively. Pressure analysis show the agitation significantly reduces the bed pressure drop, changing the fixed bed below umf and bubbling bed above umf to an agitated bed with a periodic voidage. The DL was proportional to the gas velocity, with little influences of the stirring speed. The radial tracer profiles show the bed is divided by the inner diameter of the helical ribbon into the peripheral ascending region and the central descending region, without gas exchange between them. Furthermore. the tracer profiles in the descending region are classified into two types. For type I, the DR, calculated by the plug flow model with radial dispersion, is proportional to the gas velocity, with little effects of stirring speed. Type II shows uniform profiles due to the deflection of the gas flow toward the low pressure area at the inner diameter of helical ribbon. The causes of the two types are explained by the relative size of particle circulation and gas flux. These two flow regimes are quantitatively clarified with an empirical correlation of Re and Fr as flow regime transition boundary, namely dispersed plug flow and perfect mixing flow. With lower Re and higher Fr, it changes from dispersed plug flow to perfect mixing flow.

SIMULATION FOR BULK PROPYLENE POLYMERIZATION IN LOOP REACTOR WITH THE STEP CHANGE IN FEED FLOW RATE OF MATERIAL

SIMULATION FOR LIQUID PHASE BULK PROPYLENE POLYMERIZATION IN LOOP REACTOR AT STEADY OPERATION CONDITIONS

Graft Copolymerization of Styrene and Acrylonitrile in the Presence of Poly(propylene Glycol): Modeling and Simulation of Semi‐Batch and Continuous Processes

Kinetics Of Propylene Bulk Polymerization With A Spherical Ziegler-Natta Catalyst

Modeling of an Industrial Polycondensation Process for Polyethylene Terephthalate

Simulation in a Loop Reactor for Polypropylene under a Steady Operating Condition

Simulation of Effects of Reactive Impurities on Propylene Polymerization in Loop Reactors Through Generation Function Technique

Stability and dynamic behaviors of gas-phase ethylene polymerization process under condensed mode operation

Modeling the Effect of Polymerization Rate on the Intraparticle Mass and Heat Transfer During Propylene Polymerization in A Loop Reactor

Effect of Temperature Switching and Dynamic Phase Equilibrium on Polymer Microstructure in Condensed-Mode Operation

Simulation on relative molecular mass distribution of LDPE tubular reactor

ANALYSIS ON INFLUENCING FACTORS OF PARTICLE SIZE DISTRIBUTION IN PROPYLENE POLYMERIZATION LOOP REACTOR BASED ON PARTICLE POPULATION

Mixing Effects on the Gas Flow and Mass Transfer in a Vertical Single Helical Ribbon Agitated Reactor for Propylene Polymerization

Steady-state Simulation of Reactor for Gas-phase Propylene Polymerization

A Rigorous Model for Hydrogen Response in Industrial Propylene Polymerization Loop Reactors: from Micro-Mechanism to Macro-Behavior

An Analysis on Model of a Loop Reactor for Polypropylene Under a Steady Operating Condition

Study of Particle Size Distribution in Polypropylene Loop Reactor

Intraparticle Mass and Heat Transport Model of Polypropylene in a Loop Reactor

STEADY-STATE MODELING OF COMMERCIAL LIQUID PHASE BULK PROPYLENE POLYMERIZATION

MODELING OF LOOP REACTOR FOR POLYPROPYLENE SPHERIPOL TECHNOLOGY

Mathematical Modeling of the Molecular Weight Distribution of Polypropylene Produced in a Loop Reactor