Abstract:In order to optimize and control the reactor operation in the propylene process,it is important and necessary to propose the kinetic parameters and their distributing characteristic model.According to the model,the kinetic profiles (such as the solid content,the monomer concentration,the catalyst concentration,the hydrogen concentration,the temperature in the loop reactor,the cooling water temperature,etc.) and the loop reactor length can obtained,which provides the theoretical basis for optimizing and controlling operation of propylene loop reactor,also for judging if the increasing output of polypropylene is feasible. Based on the above aims and model, this paper analyzed and solved the differential equations,which are put forward and developed in the above paper~([9]).At first,the four orders Runge-Kutta arithmetic on the basis of many literatures and the reactor data in a 70 kt/a polypropylene plant of Fujian petrochemical complex were introduced briefly.Moreover,the input parameters were given in detail on the basis of many literatures and the model results were obtained and analyzed.Based on the simulation results,the model developed can be used to describe the kinetic profiles of the loop reactor in a 70 kt/a polypropylene plant of Fujian petrochemical complex.The kinetic parameters distributing following along the loop reactor length is symmetrical and it is feasible to increase the output of polypropylene by increasing the monomer mass flux from the theory.In short,the model and its application in propylene factory of Fujian petrochemical co., ltd.are satisfactory.

Mathematical Modeling of the Molecular Weight Distribution of Polypropylene Produced in a Loop Reactor

Modeling of Molecular Weight and Copolymer Composition Distributions for Ethylene‐propylene Solution Copolymerization

Molecular Weight Distribution in Ring‐Opening Polymerization of Propylene Oxide Catalyzed by Double Metal Complex: A Model Simulation

Modeling of an Industrial Polycondensation Process for Polyethylene Terephthalate

Simulation on relative molecular mass distribution of LDPE tubular reactor

Modeling of the Molecular Weight Distribution and Short Chain Branching Distribution of Linear Low-Density Polyethylene from a Pilot Scale Gas Phase Polymerization Process

Optimal Flowsheet Configuration of a Polymerization Process with Embedded Molecular Weight Distributions

Simulation And Optimization Of The Molecular Weight Distribution In A Non-Ideal Polymerization Reactor

Coupled Single‐Particle and Population Balance Modeling for Particle Size Distribution of Poly(propylene) Produced in Loop Reactors

Steady-state Particle Size Distribution Modeling of Polypropylene Produced in Tubular Loop Reactors

Study of Particle Size Distribution in Polypropylene Loop Reactor

Operational Optimization of Polymerization Reactors with Computational Fluid Dynamics and Embedded Molecular Weight Distribution Using the Iterative Surrogate Model Method

A Segment Probability Method for Calculating the Molecular Weight Distributions of Linear Polycondensates in a Continuous Reactor

Steady-State Optimization Of An Industrial High-Density Polyethylene Slurry Process Based On An Equation-Oriented Molecular Weight Distribution Model

Dynamic simulation of molecular weight distribution of ethylene slurry polymerization

Modeling and optimization of polymer molecular weight distribution based on Kriging method

Equation-oriented optimization on an industrial high-density polyethylene slurry process with target molecular weight distribution

Steady-state simulation of polypropylene loop pilot plant

Modeling of Sequence Length Distribution for Olefin Copolymerization with Vanadium‐Based Catalyst

An Analysis on Model of a Loop Reactor for Polypropylene Under a Steady Operating Condition

Modeling of Molecular Weight Distribution of Propylene Slurry Phase Polymerization on Supported Metallocene Catalysts