Abstract:Alumina ceramics has been used widely as an industrial material because of its high heat resistance and excellent wear resistance. Nanosize metal oxide used as raw materials would decrease the sintering temperature of ceramics and enable their physical and chemical properties to be developed fully. This paper studies the synthesis of nanostructured alumina-magnesia powders. The whole compositional range for the binary Al2O3-MgO system is studied. The powder samples are characterized by X-ray diffraction (XRD), transmission electron microscopy (TEM), differential thermal analysis (DTA) and infrared spectroscopy (IRS).The results show that the nanostructured alumina-magnesia powders form solid solutions in a wide range of composition. In the alumina-rich side, the gamma-Al2O3 phase is found and the maximum amount of magnesia that can be incorporated is 30%. In the magnesia-rich side, the MgO phase is present and the range of solid solutions is from 0 to 20 wt% Al2O3 It is also found that the lattice parameter a(0) of gamma-Al2O3 increases with increase in the amount of magnesia, but the lattice parameter of the MgO phase decreases with increase in the amount of alumina. The grain size increases linearly with the amount of magnesia added and is smaller than 3.6 nm for alumina solid solution. It changes in a parabolic manner with the amount of alumina and is smaller than 15 nm for magnesia solid solution. The specific surface is about 140 m(2) g(-1) for the powders.The heat decomposition temperature of the precursor determined by DTA is not changed with increase in the amount of magnesia in the gamma-Al2O3 solid solution range. The heat decomposition temperature increases with increase in the amount of alumina in the MgO solid solution range. In the range of mixed phase, it is greater than those in the range of two solid solutions. The results for IRS of the nanostructured alumina-magnesia powders are discussed. (C) 1999 Published by Elsevier Science S.A. All rights reserved.

PREPARATION AND PROPERTIES OF ALUMINUM TITANATE SOLID SOLUTION CERAMICS

Preparation and properties of Al2O3/Al-2(1-0.2)Mg0.2Ti(1+0.2)O5 matrix ceramic composite

Synthesis of Aluminum Titanate Solid Solution by Solid State Reaction of Fine Commercial Al2o3, Tio2 and Mgo Powders

Structure ,thermal Expansion and Thermal Stability of Aluminium Titanate Materials

Intragranular Porous Aluminum Titanate Ceramics with Low Thermal Expansion and High Strength Simultaneously

RESEARCH ON SOLID-PHASE SYNTHESIS AND MODIFICATION OF ALUMINUM TITANATE

Sintering behavior and thermal shock resistance of aluminum titanate (Al2TiO5)-toughened MgO-based ceramics

Effect of Iron Oxide Nanoparticles on Thermal Stability of Aluminium Titanate Ceramics

Synthesis Of Fe-Doping Aluminum Titanate Powders

Effect of Al2O3 and TiO2 Addition Amount on Properties of MgO-based Ceramics by Coprecipitation Method

Synthesis of porous Al 2TiO 5 ceramic by reaction sintering method

The Structure and Infrared Spectra of Nanostructured MgO–Al2O3 Solid Solution Powders Prepared by the Chemical Method

Effect of Cr2O3 and Sintering Temperature on the Property of Aluminum Titanate Prepared with Alumina-Titania Slag

Fabrication of Porous Al2TiO5-Al2O3 Ceramics Using Al2O3 Hollow Spheres Coated with TiO2 Sol

Stabilization of thermal storage ceramics via the phase reconstruction of ferrotitanium slag and migration of Mg element

PREPARATION OF MULLITE-ALUMINIUM TITANATE CERAMIC COMPOSITES VIA GELCASTING

Effect Of Talc And Titania On The Microstructure And Mechanical Properties Of Alumina Ceramics

Solid-state reaction preparation and sintering behavior of MgAl 2O 4 nanopowders

Preparation of pure MgTiO3 powders and the effect of the ZnNb2O6-dope onto the property of MgTiO3-based ceramics

Effect of magnesia and silica additives on properties of aluminium titanate ceramic

Effect of Sintering Temperature on the Structures and Properties of Porous Aluminium Titanate Ceramics