Abstract:A novel three-dimensional (3D) hermetic packaging technique suitable for capacitive microelectromechanical systems (MEMS) sensors is studied. The composite substrate with through silicon via (TSV) is used as the encapsulation cap fabricated by a glass-in-silicon (GIS) reflow process. In particular, the low-resistivity silicon pillars embedded in the glass cap are designed to serve as the electrical feedthrough and the fixed capacitance plate at the same time to simplify the fabrication process and improve the reliability. The fabrication process and the properties of the encapsulation cap were studied systematically. The resistance of the silicon vertical feedthrough was measured to be as low as 263.5 mΩ, indicating a good electrical interconnection property. Furthermore, the surface root-mean-square (RMS) roughnesses of glass and silicon were measured to be 1.12 nm and 0.814 nm, respectively, which were small enough for the final wafer bonding process. Anodic bonding between the encapsulation cap and the silicon wafer with sensing structures was conducted in a vacuum to complete the hermetic encapsulation. The proposed packaging scheme was successfully applied to a capacitive gyroscope. The quality factor of the packaged gyroscope achieved above 220,000, which was at least one order of magnitude larger than that of the unpackaged. The validity of the proposed packaging scheme could be verified. Furthermore, the packaging failure was less than 1%, which demonstrated the feasibility and reliability of the technique for high-performance MEMS vacuum packaging.

A Wafer-level Protective Technique Using Glass Caps for MEMS Gyroscopes

Process Development of A New Tgv Interposer for Wafer Level Package of Inertial Mems Device

Wafer-level Vacuum Packaging with Lateral Interconnections and Vertical Feedthroughs for Microelectromechanical System Gyroscopes

An Electrostatically-driven Capacitively-sensed Frame Microgyroscope Fabricated with an Improved Process Flow

Research on a 3D Encapsulation Technique for Capacitive MEMS Sensors Based on Through Silicon Via

Chip Level Packaging for Mems Using Silicon Cap

Design and Fabrication of High Performance Wafer-Level Vacuum Packaging Based on Glass–silicon–glass Bonding Techniques

Development of wafer-level-packaging technology for simultaneous sealing of accelerometer and gyroscope under different pressures

A Bulk Micromachined Gyroscope With Improved Quality-Factors At Atmospheric Pressure

A strategy of wafer-level-plastic-packaging for MEMS based on adhesive bonding

An SOI–MEMS Technology Using Substrate Layer and Bonded Glass As Wafer-Level Package

Research on Wafer-Level MEMS Packaging with Through-Glass Vias

Wafer Lever Packaging for Gyroscope by Au/Si Eutectic Bonding

Implementation of Silicon-on-glass MEMS Devices with Embedded Through-Wafer Silicon Vias Using the Glass Reflow Process for Wafer-Level Packaging and 3D Chip Integration

Hermetic Packaging of Mems with Thick Electrodes by Silicon-Glass Anodic Bonding.

On Chip Electrostatic Discharge Protection for MEMS Gas Sensor System

Novel Silicon Cap Package Technology for Monolithic Microinertial Measurement Unit

Partially Filled TGV Based on Double Sides Cu Conformal Electroplating Process for MEMS Vacuum Packaging

Removable Fast Package Technology For Mems Devices Using Polymer Connectors And Silicon Sockets

Design, Test and Evaluation of a Novel Die-Attach Structure for Packaging Stress Suppression of MEMS Resonant Accelerometers

A Novel Packaged Ultra-High Q Silicon MEMS Butterfly Vibratory Gyroscope