Abstract:Bolted spherical joints are widely used to form space steel structures. The stiffness and load capacity of the structures are affected by the looseness of bolted spherical joint connections in the structures. The looseness of the connections, which can be caused by fabrication error, low modeling accuracy, and "false twist" in the installation process, may negatively impact the load capacity of the structure and even lead to severe accidents. Furthermore, it is difficult to detect bolted spherical joint connection looseness from the outside since the bolts connect spheres with rods together from the inside. Active sensing methods are proposed in this paper to monitor the tightness status of the bolted spherical connection using piezoceramic transducers. A triangle-on-triangle offset grid composed of bolted spherical joints and steel tube bars was fabricated as the specimen and was used to validate the active sensing methods. Lead Zirconate Titanate (PZT) patches were used as sensors and actuators to monitor the bolted spherical joint tightness status. One PZT patch mounted on the central bolted sphere at the upper chord was used as an actuator to generate a stress wave. Another PZT patch mounted on the bar was used as a sensor to detect the propagated waves through the bolted spherical connection. The looseness of the connection can impact the energy of the stress wave propagated through the connection. The wavelet packet analysis and time reversal (TR) method were used to quantify the energy of the transmitted signal between the PZT patches by which the tightness status of the connection can be detected. In order to verify the effectiveness, repeatability, and consistency of the proposed methods, the experiments were repeated six times in different bolted spherical connection positions. The experimental results showed that the wavelet packet analysis and TR method are effective in detecting the tightness status of the connections. The proposed active monitoring method using PZT transducers can monitor the tightness levels of bolted spherical joint connections efficiently and shows its potential to guarantee the safety of space steel structures in construction and service.

An Improved Diagnostic Method for Detection of Bolt Loosening in Thermal Protection Panels

A New Diagnostic Method of Bolt Loosening Detection for Thermal Protection Systems

Experimental investigation of bolt loosening detection in thermal protection panels at high temperature

Detection of bolt loosening in C–C composite thermal protection panels: II. Experimental verification

Bolt Looseness Detection Using SH Guided Wave and Wave Energy Transmission

Bolt tightness monitoring using multiple reconstructed narrowband lamb waves combined with piezoelectric ultrasonic transducer

On-Line Fault Diagnosis for Structural Health of Wind Power Dedicated Busbar Trunking

Bolt Loosening Detection Based on Piezoelectric Active Sensing Technology*

Intelligent bolt-jointed system integrating piezoelectric sensors with shape memory alloys

Electromechanical impedance instrumented wearable piezoelectric ring-type sensor for bolted connection monitoring

Health Monitoring of Bolted Spherical Joint Connection Based on Active Sensing Technique Using Piezoceramic Transducers

Dynamic Characteristics and Damage Detection of a Metallic Thermal Protection System Panel Using a Three-Dimensional Point Tracking Method and a Modal Assurance Criterion

Detection Method for Bolt Loosening and Washer Damage in Flange Assembly Structures Based on Phased Array Ultrasonics

Health Monitoring of Bolt Looseness in Timber Structures Using PZT-Enabled Time-Reversal Method

Real time bolt preload monitoring using piezoceramic transducers and time reversal technique—a numerical study with experimental verification

A novel damage index integrating piezoelectric impedance and ultrasonic guided wave for damage monitoring of bolted joints

Monitoring of corrosion-induced damage to bolted joints using an active sensing method with piezoceramic transducers

A piezoelectric active sensing method for quantitative monitoring of bolt loosening using energy dissipation caused by tangential damping based on the fractal contact theory

Development of a portable damage detection system based on electromechanical impedance technique for monitoring of bolted joint structures

Improvement of a vibration-based damage detection approach for health monitoring of bolted flange joints in pipelines

Multi-bolt looseness monitoring using guided waves: a cross-correlation approach of the wavelet energy envelope