Abstract:Abstract Within a research project carried out at the Department of Civil Engineering and the Department of Mechanical Engineering of the University of Siegen, a new monitoring method for non‐destructive damage detection on bolts was developed and tested according to its applicability on real life structures. The so‐called EMI‐method is based on the measurement of electromechanical impedance spectra, which change with varying structural states and thus allow for a condition assessment. Structures vibrate in a combination of their natural modes, which can provide information about their structural condition. Their modal characteristics are system‐inherent quantities and are governed by geometry, system stiffnesses and mass allocation. If a system parameter changes, e.g. the bending stiffness of a bridge, this is reflected in the vibration analysis and the modal characteristics. To identify the modal characteristics of civil engineering structures, these are excited and the system response is measured. This principle is also used for damage detection by means of electro‐mechanical impedance spectra (EMI). The observed system‐inherent quantity is the frequency‐dependent mechanical impedance Zs(ω) of the structure. The method is based on the idea that the mechanical impedance of a structure or component to be measured changes as a result of damage (or loss of prestress in the case of bolts) and thus these changes can be detected. In the project, investigations were carried out on steel plates with orthogonally welded threaded bolts, which are used, for example, as fasteners for rail supporting points on bridges. Research objectives were on one hand the detection of the prestress stage and on the other hand the detection of fatigue damage in the weld seam. Within the scope of the project, it has been investigated to what extent a change of the prestressing load can be reliably detected by means of the EMI method. Furthermore, the influence of damage to the bolt on the impedance spectra was investigated.

Development of a portable damage detection system based on electromechanical impedance technique for monitoring of bolted joint structures

A novel damage index integrating piezoelectric impedance and ultrasonic guided wave for damage monitoring of bolted joints

Non‐destructive damage detection on welded threaded bolts based on electromechanical impedance spectra

Impedance-Based Damage Detection for Civil Infrastructures

An Experimental Study on Bolt Looseness Monitoring Using Low-Cost Transfer Impedance Technique

Fault Detection Method of Bolt-joint Using Acceleration and Impedance

Application of electromechanical impedance-based SHM for damage detection in bolted pipeline connection

Piezoelectric Impedance Sensor-Based Structural Health Monitoring for Critical Members of Civil Infrastructures

Structural Health Monitoring Using Electro‐mechanical Impedance Sensors

Wireless Structural Health Monitoring and Early-Stage Damage Detection Using Piezoelectric Impedance Sensors

Electromechanical impedance instrumented wearable piezoelectric ring-type sensor for bolted connection monitoring

Intelligent bolt-jointed system integrating piezoelectric sensors with shape memory alloys

PZT-based active damage detection techniques for steel bridge components

Integrated Structural Health Assessment Using Piezoelectric Active Sensors

A Self-contained Active Sensor System for Health Monitoring of Civil Infrastructures

Development of an integrated sacrificial sensor for damage detection and monitoring in composite materials and adhesively bonded joints

Electromechanical impedance method for damage detection of typical joint on jacket platform

Sensor Fault Diagnosis for Impedance Monitoring Using a Piezoelectric-Based Smart Interface Technique

Entire loosening stage monitoring of bolted joints via nonlinear electro-mechanical impedance spectroscopy

Impedance‐based looseness detection of bolted joints using artificial neural network: An experimental study

A NEW ACTIVE SENSING DEVICE FOR WIRELESS TELEMETRY- BASED STRUCTURAL HEALTH MONITORING