Abstract:Abstract Within a research project carried out at the Department of Civil Engineering and the Department of Mechanical Engineering of the University of Siegen, a new monitoring method for non‐destructive damage detection on bolts was developed and tested according to its applicability on real life structures. The so‐called EMI‐method is based on the measurement of electromechanical impedance spectra, which change with varying structural states and thus allow for a condition assessment. Structures vibrate in a combination of their natural modes, which can provide information about their structural condition. Their modal characteristics are system‐inherent quantities and are governed by geometry, system stiffnesses and mass allocation. If a system parameter changes, e.g. the bending stiffness of a bridge, this is reflected in the vibration analysis and the modal characteristics. To identify the modal characteristics of civil engineering structures, these are excited and the system response is measured. This principle is also used for damage detection by means of electro‐mechanical impedance spectra (EMI). The observed system‐inherent quantity is the frequency‐dependent mechanical impedance Zs(ω) of the structure. The method is based on the idea that the mechanical impedance of a structure or component to be measured changes as a result of damage (or loss of prestress in the case of bolts) and thus these changes can be detected. In the project, investigations were carried out on steel plates with orthogonally welded threaded bolts, which are used, for example, as fasteners for rail supporting points on bridges. Research objectives were on one hand the detection of the prestress stage and on the other hand the detection of fatigue damage in the weld seam. Within the scope of the project, it has been investigated to what extent a change of the prestressing load can be reliably detected by means of the EMI method. Furthermore, the influence of damage to the bolt on the impedance spectra was investigated.

Electromechanical impedance method for damage detection of typical joint on jacket platform

An Experimental Study of Damage Detection on Typical Joints of Jackets Platform Based on Electro-Mechanical Impedance Technique

Structural Health Monitoring Using High-Frequency Electromechanical Impedance Signatures

An electromechanical impedance approach for quantitative damage detection in Timoshenko beams with piezoelectric patches

An Electromechanical Impedance‐Based Imaging Algorithm for Damage Identification of Chemical Milling Stiffened Panel

Non‐destructive damage detection on welded threaded bolts based on electromechanical impedance spectra

Model experiments of damaged structural identification based on electro-mechanical impedance technique

A novel data-based approach for monitoring fatigue crack propagation in welded joints under varying ambient temperature using the electromechanical admittance

Application of Emi Technique for Crack Detection in Continuous Beams Adhesively Bonded with Multiple Piezoelectric Patches

Acoustic Emission Characterization of Damage Patterns in Composite Scarf Joints Using Unsupervised Learning

Development of a portable damage detection system based on electromechanical impedance technique for monitoring of bolted joint structures

Application of electromechanical impedance-based SHM for damage detection in bolted pipeline connection

Structural Health Monitoring Using Electro‐mechanical Impedance Sensors

Quantitative Structural Damage Detection Using High-Frequency Piezoelectric Signatures Via The Reverberation Matrix Method

A review of structural health monitoring of bonded structures using electromechanical impedance spectroscopy

Damage Identification in Plate Structures Using Sparse Regularization Based Electromechanical Impedance Technique

A Coupled Approach for Damage Detection of Framed Structures Using Piezoelectric Signature

A novel damage index integrating piezoelectric impedance and ultrasonic guided wave for damage monitoring of bolted joints

Multiple Crack Detection of Concrete Structures Using Impedance-based Structural Health Monitoring Techniques

Electromechanical Impedance-based Health Diagnosis for Tendon and Anchorage Zone

Health monitoring of bonded joints through electrical measurements