Abstract:Quality assurance of adhesively bonded joints is of vital importance if their benefits are to be exploited across a wide range of industrial applications. A novel lightweight, low-cost, non-invasive embedded sacrificial sensor is proposed, capable of detecting damage within an adhesively bonded joint, which could also be used in a laminated composite structure. The sensor operation uses changes in electrical resistance, increasing as the sensing material area diminishes with damage progression. Initial tests prove the sensor concept by showing that the electrical resistance of the sensor increases proportionally with material removal, mimicking the sensor operation. Thermography is used to verify the current flow through the sensor and that any localised heating caused by the sensor is minimal. Short beam interlaminar shear strength (ILSS) tests show that embedding sensors in a composite laminates did not cause a reduction in material interfacial structural performance. Finally, the in situ performance of the sensor is demonstrated in quasi-static tensile tests to failure of adhesively bonded single lap joints (SLJs) with sensors embedded in the bond line. Prior to crack initiation, an electrical response occurs that correlates with increasing applied load, suggesting scope for secondary uses of the sensor for load monitoring and cycle counting. Crack initiation is accompanied by a rapid increase in electrical resistance, providing an indication of failure ahead of crack propagation and an opportunity for timely repair. As the crack damage propagated, the electrical response of the sensor increased proportionally. The effect of the sensor on the overall structural performance was assessed by comparing the failure load of joints with and without the embedded sensor with no measurable difference in ultimate strength. The research presented in the article serves as an important first step in developing a simple yet promising new technology for structural health monitoring with numerous potential applications.

Health monitoring of bonded joints through electrical measurements

Self-sensing Joints for In-Situ Structural Health Monitoring of Composite Pipes: A Piezoresistive Behavior-Based Method

Monitoring Crack Tip Position in Adhesively Bonded Joints Under Mixed I+II Mode Loading

A review of structural health monitoring of bonded structures using electromechanical impedance spectroscopy

S : simple quasi-1D model for structural health monitoring of single lap joint software

Acoustic Emission Based Monitoring of Fatigue Damage in CFRP-CFRP Adhesive Bonded Joints

The Health Monitoring of Bonded Composite Joints Using Both Thickness and Radial Impedance Resonance Responses

Estimation of Crack Tip Position in Adhesively Bonded Joints Subjected to Mode II Fatigue Loading

Evaluation of Fatigue Damage Monitoring of Single-Lap Composite Adhesive Joint Using Conductivity

Damage monitoring of pinned hybrid composite-titanium joints using direct current electrical resistance measurement

Structural Health Monitoring of Composite Laminates in Thermoplastic Induction Welded Joints using Electromagnetic Field Technique

Towards a practical structural health monitoring technology for patched cracks in aircraft structure

Development of an integrated sacrificial sensor for damage detection and monitoring in composite materials and adhesively bonded joints

Multiple Crack Detection of Concrete Structures Using Impedance-based Structural Health Monitoring Techniques

Electro-Mechanical Impedance-Based Structural Health Monitoring of Fiber-Reinforced Concrete Specimens under Four-Point Repeated Loading

Monitoring the crack lengths in composite lap joints under cyclic loading

A novel data-based approach for monitoring fatigue crack propagation in welded joints under varying ambient temperature using the electromechanical admittance

Electromechanical impedance method for damage detection of typical joint on jacket platform

Bridge Health Monitoring Using Strain Data and High-Fidelity Finite Element Analysis

Structural Health Monitoring Using Electro‐mechanical Impedance Sensors

Structural health monitoring of carbon nanotube-modified glass fiber-reinforced polymer composites by electrical resistance measurements and digital image correlation