Abstract:uThe factor that plays important role in the quality of the final product in selective laser melting (SLM) is the process parameter set used in production. In general, these fabrication parameter sets are obtained experimentally by using the energy density requirements of the material. The experimental investigation is partly a trial and error approach, which is a time and cost-consuming process. On the other hand, keeping the temperature of the melt pool in an allowable range, which is dominated by the applied process parameters sets, and preventing temperature fluctuations impress the stability of the production and therefore the quality of the final product. The paper presents a multiphysics numerical model approach for obtaining parameters in an SLM process by using AlSi10Mg powders as the material medium. The proposed approach provides mathematical relationships between the process parameters and the temperature they form. By investigating the effect of laser power and laser spot diameter on the temperature at different scanning velocities, wider process parameter sets were obtained for AlSi10Mg. In addition, mathematical relationships between laser power-temperature and laser spot diameter-temperature at different scanning velocities, which will be the base material to design a controller to control the melt pool temperature instantly, were developed. By using the parameter sets obtained from the simulations, test samples including samples for microstructure study and tensile test specimens were fabricated to validate the model. The un-melted powders and nonconnected melt pool defects due to insufficient temperature, evaporation defects caused by extreme temperature, and appropriate and homogeneous microstructures as a result of suitable parameters that were predicted through simulations, affecting microstructure and mechanical properties, validated the model. The experimental study was carried out by examining the microstructure and tensile properties of the fabricated test samples.

Study on the Process Parameters of Selective Laser Sintering Foundry Silica Sands

Effect of process parameters on microstructures and properties of Al-42Si alloy fabricated by selective laser melting

Coupling Analysis on Microstructure and Residual Stress in Selective Laser Melting (SLM) with Varying Key Process Parameters

Experimental investigating and numerical simulations of the thermal behavior and process optimization for selective laser sintering of PA6

Experimental Research on Selective Laser Melting AlSi10Mg Alloys: Process, Densification and Performance

Effect of Processing Parameters on Tensile Properties and Microstructure of Selective Laser Melted AlSi10Mg Alloy

Effects of process parameters on dimensional precision and tensile strength of wax patterns for investment casting by selective laser sintering

Achievement of a Parameter Window for the Selective Laser Melting Formation of a GH3625 Alloy

Simulation and experimental studies on process parameters, microstructure and mechanical properties of selective laser melting of stainless steel 316L

Effects of raw material ratio and post-treatment on properties of soda lime glass-ceramics fabricated by selective laser sintering

Process optimization of micro selective laser melting and comparison of different laser diameter for forming different powder

Effect of laser parameters on microstructure and phase evolution of Ti-Si-C composites prepared by selective laser melting

Study of the Effect of Selective Laser Melting Process Parameters on Overhang Structures

Selective laser melting of CuCrZr alloy: processing optimisation, microstructure and mechanical properties

Numerical Simulation and Parametric Analysis of Selective Laser Melting Process of AlSi10Mg Powder

On the selective laser melting based additive manufacturing of AlSi10Mg: The process parameter investigation through multiphysics simulation and experimental validation

A simulation model of selective laser melting (SLM) of glass silica monolayer

Effects of selective laser melting parameters on surface quality and densification behaviours of pure nickel

Effect of process parameters on the densification of SLM-produced Mg–Y–Sm–Zn–Zr alloy

Study of residual stress in selective laser melting of Ti6Al4V

Process Optimization of Selective Laser Melting Nickel-Based Superalloy