Abstract:Finger seal is a type of compliant seal configuration that has superior sealing performance compared with conventional labyrinth seals and brush seals. However, complex working conditions lead to leakage, thermal gradient and deformation, which can be more serious for a contacting finger seal due to frictional heating. In this paper, a leakage and thermal performance analysis method coupled with porous media and a real structure model was developed to numerically simulate the leakage, heat transfer and thermal deformation characteristics of a contacting finger seal. The method innovatively established a porous media fluid dynamics and heat transfer model and modified the frictional heating model by introducing the concept of a friction work conversion ratio. Then, the thermal deformation of the fingers was calculated on the basis of pressure and temperature results by using the thermal-stress module of ANSYS Workbench. The results show that the leakage analysis porous media model has good calculation accuracy and most of the fluid leaks through the finger foot, while the pressure drops mainly in this field. The highest finger temperature occurs at the downstream side of the contact surface between the finger foot and the rotor. The largest thermal deformation of each laminate occurs at the finger foot toe and increases slightly along the flow direction. Additionally, the largest relative circumferential thermal deformation can reduce the gap between the fingers by approximately 5%, which is beneficial for reducing leakage. It is suggested to increase the seal inner diameter at the finger foot toe but decrease it at the finger foot heel during the design process to decrease wear and leakage.

Analysis on Temperature Field of Mechanical Face Seals Using Ansys

Analytical and Experimental Method of Thermal Load Estimation for Seals in Transmission of Vehicle

Finite Element Analysis of Spindle Thermal Character Based on Thermal Contact Resistance

Coupling Analysis of Frictional Heat of Fluid Film and Thermal Deformation of Mechanical Seal End Faces

Three-Dimensional Coupling Analysis of Flow and Thermal Performance of A Mechanical Seal

Numerical Analysis of Heat Transfer Coefficient in Mechanical Face Seals

Experimental and numerical stady on temperature field of mechanical seal

Calculation Method of Mechanical Seal Temperature Distribution Based on Heat Conduction Angle

Thermal Fluid-Solid Interaction Model and Experimental Validation for Hydrostatic Mechanical Face Seals

Thermo-mechanical coupling analysis of the end faces for a mechanical seal under dry friction

Analysis of thermal-mechanical coupling strength and fatigue life of cylinder head

Temperature Field and Performance Analysis of Brush Seals Based on FEA-CFD and the Porous Medium of Anisotropic Heat Transfer Models

FULL NUMERICAL SIMULATION TO THE PERFORMANCE OF MICRO-TEXTURED MECHANICAL FACE SEALS

Sealing Performance Analysis of an End Fitting for Marine Unbonded Flexible Pipes Based on Hydraulic-Thermal Finite Element Modeling

Prediction of Seal Wear with Thermal-Structural Coupled Finite Element Method

Failure Analysis and Improvement of Mechanical Seals in Underwater Turbine

Theoretical and experimental approach for the characteristics of water-lubricated, high-speed double spiral-groove face seals

Leakage, heat transfer and thermal deformation analysis method for contacting finger seals based on coupled porous media and real structure models

Analysis of Thermoelastic Contact of Gas-Lubricated Rough Sealing Faces

Analysis of the coupling mechanism of the dynamic response and mechanical-thermal deformation in mechanical seals

Friction and Temperature Reduction in a Mechanical Face Seal by a Surface Texturing: Comparison between TEHD Simulations and Experiments