Abstract:In this study, a new casing process named expendable pattern shell casting process with vacuum and low pressure (EPSC-VL) was introduced to produce complicated and thin-walled aluminum alloy castings. The gas flowrate is one of the most important process parameters for manufacturing castings during the EPSC-VL process. In the present work, the influence of gas flowrate on the filling ability and internal quality of A356 aluminum alloy castings fabricated by the EPSC-VL process were investigated. Moreover, the filling ability, internal quality, as well as mechanical properties of A356 aluminum alloy castings obtained by EPSC-VL and lost foam casting (LFC) processes were also compared. The results obtained suggested that the filling length increased with the increase of gas flowrate, and the filling length of the thick section was larger than that of the thin section under the same gas flowrate when the gas flowrate was less than 19 m(3)/h. Furthermore, the porosity of castings decreased with increasing gas flowrate, and the microstructure of castings became denser, and the internal quality of castings was obviously improved. The comparison experiments showed that the EPSC-VL process had superior filling ability, internal quality, and mechanical properties compared with the LFC process, and the surface quality of castings obtained by EPSC-VL process was also better than that of the LFC process. The casting practice of complicated and thin-walled A356 aluminum alloy intake manifold part also suggested that the EPSC-VL process had an obvious advantage for the fabrication of complicated and thin-walled aluminum alloy castings compared with the LFC process.

Comparison of Filling Process of A356 Alloy in Semi-solid Thixo-forming Die Casting with in Conventional Die Casting Based on Numerical Simulation with Flow-3D

Numerical Simulation of Cavity-Filling Procedures for Micro-Pin-fin Array Thixoforming with Semi-Solid A356 Aluminium Alloy

Comparison of Rheological Models to Simulate Die Filling Process of A356 Semisolid Alloy

On the Size Effects in Micro/meso Semisolid Extrusion–forging of A356 Aluminum Alloy

Multiphase modelling of the transient flow for Sn-15Pb and 357.0 alloys in semi-solid die casting process

Study on Numerical Simulation of Mold Filling and Heat Transfer in Die Casting Process

Numerical Simulation and Experimental Investigation of Microstructure Evolution and Flow Behavior in the Rheological Squeeze Casting Process of A356 Alloy

Experimental and simulation study for rewelding defects during the flow process of Semi-solid die casting

Direct Observation of Filling Process and Porosity Prediction in High Pressure Die Casting

Numerical Simulation of Fluid Flow and Heat Transfer During Mold Filling for Die Casting

Modeling of filling and solidification process for TiAl exhaust valves during suction casting

Numerical simulation on semi-solid die-casting of magnesium matrix composite based on orthogonal experiment

Water Analogue Experimental Study on the Filling Process of A Steam Turbine Housing Casting

Study and Application of Cae Simulation in Die-Casting Die Design

Simulation of semisolid diecasting process of four-way valve of HPb59-1 alloy for air-conditioner

Die-Casting Die Design Based on the Application of Cae Simulation

Water Analogue Validation of Numerical Model for Fluid Flow During Slow Shot Phase in Die Casting Process

Numerical Simulation of Lost-Foam Casting for Key Components of A356 Aluminum Alloy in New Energy Vehicles

Three Dimension Simulation of Lost Foam Casting Straight Six-cylinder Engine Housing

Simulation Analysis on Micro Hole Forming of Aluminum Alloy in Extrusion Casting Process

Influence of Gas Flowrate on Filling Ability and Internal Quality of A356 Aluminum Alloy Castings Fabricated Using the Expendable Pattern Shell Casting with Vacuum and Low Pressure