Abstract:The most common defect found in the high pressure die casting(HPDC) process is gas porosity which significantly affects the mechanical properties of the final components.As it is known,the air entrapment of the liquid metal flow during the mold filling stage has a close relationship with the gas porosity distribution in die castings.The generation of the entrapped air is mainly due to the interaction between air and liquid metal in the die cavity.In the past few decades,extensive efforts have been made to develop numerical models for the simulation of mold filling.However,these efforts mainly focused on the single phase flow models which can only predict the liquid metal flow and assume that the effect of air in the die cavity is negligible.As a result, these models could not provide the quantity and location of entrapped air in die castings.Recently, several research results on tracking the entrapped air in the molten metal flow have been reported but some techniques still need to be improved further and much more researches are required.In this study,a liquid-gas coupled model is presented to simulate the air entrapment phenomenon during the HPDC mold filling process.The pressure of the entrapped air bubbles is solved at each time step. The calculations of the liquid and gas phases are combined together through the pressure transfer.In order to verify the validity and stability of this model,a specially designed water analog experiment was carried out and compared with the numerical simulation results of the liquid-gas coupled model and the single phase flow model,respectively.The comparison shows that the liquid-gas coupled model has better prediction accuracy than the single phase flow model in tracking the entrapped air bubbles.

Three Dimension Simulation of Lost Foam Casting Straight Six-cylinder Engine Housing

Numerical Simulation of Lost-Foam Casting for Key Components of A356 Aluminum Alloy in New Energy Vehicles

Die Structure Optimization of Aluminum Alloy Wheel Low-Pressure Die Casting Based on CAE

Three-Dimensional Simulation of EPS Evaporation Process for Lost Foam Casting

Determination of casting parameters of thick wall die-casting of magnesium alloy and simulation of its processing

Study on Numerical Simulation of Mold Filling and Heat Transfer in Die Casting Process

Numerical Simulation of Casting Filling Process of Composites Reinforced with Nano SiC Based on Smoothed Particle Hydrodynamics

Numerical Simulation and Experimental Validation of Squeeze Casting of AlSi9Mg Aluminum Alloy Component with a Large Size

Comparison of Filling Process of A356 Alloy in Semi-solid Thixo-forming Die Casting with in Conventional Die Casting Based on Numerical Simulation with Flow-3D

Numerical Simulation and Optimization of Indirect Squeeze Casting Process

Study and Application of Cae Simulation in Die-Casting Die Design

Numerical Simulation of Air Entrapment Phenomenon During Mold Filling of High Pressure Die Casting Process

Numerical Simulation and the Application for Filling Process of Expendable Polystyrene Beads in Lost-foam Casting

Die-Casting Die Design Based on the Application of Cae Simulation

Casting defects and microstructure distribution characteristics of aluminum alloy cylinder head with complex structure

Solidification simulation of automobile wheel in low pressure casting

Numerical Simulation of the Injection of Expanded Beads in Lost Foam Casting

Numerical simulation and optimization of liquid metal flow in the shot sleeve of cold chamber die casting process

Direct Observation of Filling Process and Porosity Prediction in High Pressure Die Casting

Study and Application of Mold Filling Simulation of Shaped Castings

Numerical Simulation of Fluid Flow and Heat Transfer During Mold Filling for Die Casting