Abstract:The most common defect found in the high pressure die casting(HPDC) process is gas porosity which significantly affects the mechanical properties of the final components.As it is known,the air entrapment of the liquid metal flow during the mold filling stage has a close relationship with the gas porosity distribution in die castings.The generation of the entrapped air is mainly due to the interaction between air and liquid metal in the die cavity.In the past few decades,extensive efforts have been made to develop numerical models for the simulation of mold filling.However,these efforts mainly focused on the single phase flow models which can only predict the liquid metal flow and assume that the effect of air in the die cavity is negligible.As a result, these models could not provide the quantity and location of entrapped air in die castings.Recently, several research results on tracking the entrapped air in the molten metal flow have been reported but some techniques still need to be improved further and much more researches are required.In this study,a liquid-gas coupled model is presented to simulate the air entrapment phenomenon during the HPDC mold filling process.The pressure of the entrapped air bubbles is solved at each time step. The calculations of the liquid and gas phases are combined together through the pressure transfer.In order to verify the validity and stability of this model,a specially designed water analog experiment was carried out and compared with the numerical simulation results of the liquid-gas coupled model and the single phase flow model,respectively.The comparison shows that the liquid-gas coupled model has better prediction accuracy than the single phase flow model in tracking the entrapped air bubbles.

Numerical Simulation of the Injection of Expanded Beads in Lost Foam Casting

Numerical Simulation and the Application for Filling Process of Expendable Polystyrene Beads in Lost-foam Casting

Numerical simulation of filling flow of polymer melt in injection molding

Numerical Simulation of Die-Casting Mold Filling Process Based on Fractional Step Method

Three-Dimensional Simulation of EPS Evaporation Process for Lost Foam Casting

Numerical Simulation of Casting Filling Process of Composites Reinforced with Nano SiC Based on Smoothed Particle Hydrodynamics

Numerical Simulation of Multiphase Flow in Steel Continuous Casting Mold Using a Novel Euler–Euler–Lagrange Method

Numerical Simulation of Lost-Foam Casting for Key Components of A356 Aluminum Alloy in New Energy Vehicles

Three Dimension Simulation of Lost Foam Casting Straight Six-cylinder Engine Housing

Numerical Simulation and Optimization of Indirect Squeeze Casting Process

Numerical Simulation of Fluid Flow and Heat Transfer During Mold Filling for Die Casting

Modeling of Mold Filling and Solidification in Lost Foam Casting

Large Eddy Simulation on the Two‐Phase Flow in a Water Model of Continuous Casting Strand with Gas Injection

Numerical simulation of mold filling of casting with an improved SOLA-VOF method

Mold Filling Model for Lost Foam Casting

Experimental Study on the Filling Process of the Lost Foam Casting Process of a Cast Iron Plate

Numerical simulation of reaction injection molding with polyurethane foam

The Numerical Simulation of Flow Field of the Slow Shot Phase in the Shot Sleeve

Numerical Simulation of Mold Filling and Solidification of a Nickel Alloy Vane Investment Casting

Numerical Simulation of Air Entrapment Phenomenon During Mold Filling of High Pressure Die Casting Process

An Approach for Mold Filling Simulation in Lost Foam Casting