Abstract:One of the important failure criteria of press operations in industry for forming simulations is the Forming Limit Diagram (FLD). The complex loading effects on FLD, in particular the localized necking phenomenon under stretch-bending condition, have not been fully investigated and well understood. In practical sheet metal applications, the deformation is invariably three dimensional with a combination of stretching and bending. For most sheet materials under these complex loading processes used in industry, strong Bauschinger effect is observed, and the material hardening behavior tends to be anisotropic. This study aims to understand and evaluate such anisotropic hardening effect on the forming limit prediction under stretch-bending condition. The extended through-thickness Marciniak–Kuczynski (M–K) analysis is incorporated with Yoshida–Uemori (YU) two-surface kinematic hardening constitutive model, which has a more accurate description of the reverse loading behavior than that of the conventional isotropic hardening model. The material parameters used in this paper for YU model are calibrated with the experimental data from uniaxial large-strain tension-compression cyclic test. Both the isotropic hardening and YU kinematic hardening models with Hill'48 yield surface are employed in the analysis for the purpose of comparison. The Forming Limit Average Stress Diagram (FLASD) under stretch-bending condition is proposed to extend the understanding of Forming Limit Stress Diagram (FLSD) from in-plane to out-of-plane deformations. The “bending-ratio-dependent” phenomenon in forming limit diagram is predicted and observed in both stress/strain space with the proposed method. It suggests that the individual stress/strain state cannot represent system behavior. Forming limits under stretch-bending is suggested as an occurrence of system instability, not individual material instability. The system behavior of sheet metal deformation is reinforced as critical to the understanding of necking instability in stretch bending processes. The analysis shows that the Bauschinger effect provides positive effect in delaying the necking instability, predicting higher formability for sheet metals under stretch-bending. The insight obtained in this paper provides further understanding of the localized necking phenomenon under stretch-bending condition.

Sheet metal forming limit prediction with minimum thickness criterion in numerical simulation

Sheet Metal Forming Limit Prediction with Maximum Thickness Reduction Ratio

Sheet Metal Forming Limit Prediction Based on Plastic Deformation Energy

A Method for Prediction of Forming Strain for Cold Stamping Formed Head Made of S30408 Austenitic Stainless Steel

Experimental and Numerical Investigation on Sheet Metal Forming Limit Prediction with Thickness Related Criteria

New Forming Limit Prediction Criterion for Sheet Metals

The Theoretical Prediction and Numerical Simulation of Sheet Metal Forming Limit

An Experimental and Theoretical Study on Constitutive Model of Al-2024T4 for Sheet Metal Incremental Forming

Fracture Prediction in Spin Forming of Anisotropic Metal Sheets

Application of Minimum Thickness Criterion in Forecasting FLC of High-Strength Hot Rolled-Sheet Metal

Suitability of some ductile fracture criteria and yield criteria in forming limit prediction

Modeling and Predicting of Aeronautical Thin-Walled Sheet Metal Parts Riveting Deformation

Prediction of Forming Limit for Aluminum Alloy Sheet Coupling with Temperature and Strain Rate

A Numerical M-K Approach for Predicting the Forming Limits of Material AA5754-O

An extended mesoscaled M-K model for predicting discrete ultimate strains and evaluating the effect of normal stress on forming limits

Experimental and Theoretical Investigations of the Forming Limit of 5754O Aluminum Alloy Sheet under Different Combined Loading Paths

Prediction of Micro/meso Scale Forming Limit for Metal Foils Using a Simple Criterion

Prediction of Forming Limits for Anisotropic Materials with Nonlinear Strain Paths by an Instability Approach

Forming limit of hot-rolled high-strength steels considering sheet thickness effect

Analytical Modeling of Fracture Strain and Experimental Validation in Incremental Sheet Forming

Sheet metal forming limits under stretch-bending with anisotropic hardening