Abstract:One of the important failure criteria of press operations in industry for forming simulations is the Forming Limit Diagram (FLD). The complex loading effects on FLD, in particular the localized necking phenomenon under stretch-bending condition, have not been fully investigated and well understood. In practical sheet metal applications, the deformation is invariably three dimensional with a combination of stretching and bending. For most sheet materials under these complex loading processes used in industry, strong Bauschinger effect is observed, and the material hardening behavior tends to be anisotropic. This study aims to understand and evaluate such anisotropic hardening effect on the forming limit prediction under stretch-bending condition. The extended through-thickness Marciniak–Kuczynski (M–K) analysis is incorporated with Yoshida–Uemori (YU) two-surface kinematic hardening constitutive model, which has a more accurate description of the reverse loading behavior than that of the conventional isotropic hardening model. The material parameters used in this paper for YU model are calibrated with the experimental data from uniaxial large-strain tension-compression cyclic test. Both the isotropic hardening and YU kinematic hardening models with Hill'48 yield surface are employed in the analysis for the purpose of comparison. The Forming Limit Average Stress Diagram (FLASD) under stretch-bending condition is proposed to extend the understanding of Forming Limit Stress Diagram (FLSD) from in-plane to out-of-plane deformations. The “bending-ratio-dependent” phenomenon in forming limit diagram is predicted and observed in both stress/strain space with the proposed method. It suggests that the individual stress/strain state cannot represent system behavior. Forming limits under stretch-bending is suggested as an occurrence of system instability, not individual material instability. The system behavior of sheet metal deformation is reinforced as critical to the understanding of necking instability in stretch bending processes. The analysis shows that the Bauschinger effect provides positive effect in delaying the necking instability, predicting higher formability for sheet metals under stretch-bending. The insight obtained in this paper provides further understanding of the localized necking phenomenon under stretch-bending condition.

Sheet Metal Forming Limit Prediction Based on Plastic Deformation Energy

New Forming Limit Prediction Criterion for Sheet Metals

Sheet Metal Forming Limit Prediction with Maximum Thickness Reduction Ratio

A Method for Prediction of Forming Strain for Cold Stamping Formed Head Made of S30408 Austenitic Stainless Steel

Sheet metal forming limit prediction with minimum thickness criterion in numerical simulation

An Experimental and Theoretical Study on Constitutive Model of Al-2024T4 for Sheet Metal Incremental Forming

Fracture Prediction in Spin Forming of Anisotropic Metal Sheets

Suitability of some ductile fracture criteria and yield criteria in forming limit prediction

The Theoretical Prediction and Numerical Simulation of Sheet Metal Forming Limit

Analysis of Forming Limits Based on a New Ductile Damage Criterion in St14 Steel Sheets

Prediction of Forming Limit for Aluminum Alloy Sheet Coupling with Temperature and Strain Rate

Sheet metal forming limits under stretch-bending with anisotropic hardening

Prediction of Strain Path Changing Effect on Forming Limits of AA 6111-T4 Based on a Shear Ductile Fracture Criterion

Prediction of Forming Limit in Dp590 Steel Sheet Forming: an Extended Fracture Criterion

Damage and forming limit analysis in porous ductile sheet metals at room or elevated temperatures

Prediction of Forming Limits for Anisotropic Materials with Nonlinear Strain Paths by an Instability Approach

An extended mesoscaled M-K model for predicting discrete ultimate strains and evaluating the effect of normal stress on forming limits

Fracture prediction for metal sheet deformation under different stress states with uncoupled ductile fracture criteria

Analytical Modeling of Fracture Strain and Experimental Validation in Incremental Sheet Forming

Ideal Forming and Design of Sheet Metal Forming

Recent Research Advance of Application of Ductile Fracture Criteria in Sheet Metal Forming Process