Abstract:The flow condensation heat transfer coefficient of R134a inside two helical micro-fin tubes with outer diameter of 6.35 mm and helical angles of 18o and 28o respectively were experimentally studied at a high mass flux ranging from 500 to 1100 kg m−2 s−1. The condensation temperatures are 35°C, 40°C and 45°C, and the vapor qualities ranges from 0.95 to 1.00 at the inlet section and from 0.00 to 0.05 at the outlet section. Experimental results show that there are annular and intermittent flow regimes inside the tube under experimental conditions, the ratio of annular flow region to the total heat transfer region is about 70%. The liquid film flow changes from rotational flow to coexistence of rotational and horizontal flows when the vapor quality is 0.475±0.08, 0.486±0.06 and 0.521±0.05, respectively and the corresponding saturation temperature is 35°C, 40°C and 45°C. Based on the experimental data, the heat transfer coefficient increases with increasing mass flux and fin helical angle, and with decreasing saturation temperature and Reynolds number of cooling water. In addition, the heat transfer coefficient of annular flow is greater than that of intermittent flow, in other words, the heat transfer coefficient increases with increasing vapor quality. The heat transfer coefficient obtained at high mass flux was compared with the calculated data of some published correlations used at low mass flux. It was found that most correlations underestimate the experimental heat transfer coefficient inside the micro-fin tube, and these prediction deviation increases with increasing mass flux and fin helical angle. By introducing some dimensionless numbers as well as considering the flow mechanism of liquid film inside the tube, two heat transfer coefficient correlations were proposed based on the experimental data. The ratio of liquid film thickness to fin height was used to characterize whether the liquid film flow is rotational flow or coexistence of rotational and horizontal flows in the proposed correlation, which shows a better prediction accuracy with a mean deviation of less than 7.3%.

Study on Micro Modeling Equipment of Condenser-Throat

Thermoacoustic Model For Time-Averaged Flowing Streaming Within Parallel Plate And Cylindrical Tube Subjected To Oscillating Flow

Numerical study on the complicated flow filed of steam turbine condenser throat

Three-Dimensional Numerical Simulation of the Flow Field in Condenser Throat with Flow Guide Dev

Numerical Study on the Outlet Flow Field of the 300MW Steam Turbine’s Condenser Throat with Flow Guide Devices

Theoretical and Experimental Analyses of Two-Phase Flow Condensation Heat Transfer Inside the Horizontal Micro-Fin Tube

Experimental Study of Condensation Heat Transfer of R134a Inside the Micro-Fin Tubes at High Mass Flux

Thermal simulation of micro-channel flat tube condenser for refrigerator

Physical Model and Numerical Simulation Approach of Steam Flow and Heat Transfer of Pannier-arrangement Condensers

Modeling and experimental study of air-cooled finned-tube condenser using coupled distribution parameter method and air-side temperature distribution

Numerical Simulation and Analysis of Micro-channel Condenser

Influence Mechanism on Flow and Heat Transfer Characteristics for Air-Cooled Steam Condenser Cells

Thermal analysis and performance investigations of shell and tube heat exchanger using numerical simulations

Simulation Study on Fin-tube Condenser

Research on fluid flow and heat transfer characteristics in a three-dimensional condenser

Simulation of Micro-Channel two Phase Heat Exchanger on Various Working Conditions

Heat transfer characteristics in vertical tube condensers: Experimental investigation and numerical validation

Non-Condensation Turbulence Models with Different Near-Wall Treatments and Solvers Comparative Research for Three-Dimensional Steam Ejectors

Numerical Simulations of a Micro-Channel Wall-Tube Condenser for Domestic Refrigerators

A Review on the Research of Flow and Heat Transfer in Steam Condensing

Development of Small-diameter Tube Heat Exchanger : Circuit Design and Performance Simulation