Abstract:The flow condensation heat transfer coefficient of R134a inside two helical micro-fin tubes with outer diameter of 6.35 mm and helical angles of 18o and 28o respectively were experimentally studied at a high mass flux ranging from 500 to 1100 kg m−2 s−1. The condensation temperatures are 35°C, 40°C and 45°C, and the vapor qualities ranges from 0.95 to 1.00 at the inlet section and from 0.00 to 0.05 at the outlet section. Experimental results show that there are annular and intermittent flow regimes inside the tube under experimental conditions, the ratio of annular flow region to the total heat transfer region is about 70%. The liquid film flow changes from rotational flow to coexistence of rotational and horizontal flows when the vapor quality is 0.475±0.08, 0.486±0.06 and 0.521±0.05, respectively and the corresponding saturation temperature is 35°C, 40°C and 45°C. Based on the experimental data, the heat transfer coefficient increases with increasing mass flux and fin helical angle, and with decreasing saturation temperature and Reynolds number of cooling water. In addition, the heat transfer coefficient of annular flow is greater than that of intermittent flow, in other words, the heat transfer coefficient increases with increasing vapor quality. The heat transfer coefficient obtained at high mass flux was compared with the calculated data of some published correlations used at low mass flux. It was found that most correlations underestimate the experimental heat transfer coefficient inside the micro-fin tube, and these prediction deviation increases with increasing mass flux and fin helical angle. By introducing some dimensionless numbers as well as considering the flow mechanism of liquid film inside the tube, two heat transfer coefficient correlations were proposed based on the experimental data. The ratio of liquid film thickness to fin height was used to characterize whether the liquid film flow is rotational flow or coexistence of rotational and horizontal flows in the proposed correlation, which shows a better prediction accuracy with a mean deviation of less than 7.3%.

Simulation Study on Fin-tube Condenser

An Experiment and Simulation Study on Performance of Finned Tube Condenser

The simulation and analysis of fin-tube evaporator for air-conditioning

Simulation Study of a Multi-unit Parallel-flow Condenser

Modeling and experimental study of air-cooled finned-tube condenser using coupled distribution parameter method and air-side temperature distribution

Study on Characteristics of Heat Transfer about Air-Cooling Finned Tube Exchanger

A universal simulation model of air-cooled condenser consisting of plate-fin-tube

Numerical Simulation and Optimization of Condensation and Heat Transfer Characteristics on the Air-Side of Fin-and-Tube Heat Exchangers

Experimental Study of Condensation Heat Transfer of R134a Inside the Micro-Fin Tubes at High Mass Flux

Simulation of Fin-and-tube Heat Exchanger Based on Two-phase Fluid Network

Numerical Investigation on Air Flow and Heat Transfer Performance Outside Triple Row Tube Used in Air Cooling Condenser

Numerical Simulation on Air-Side Fluid Flow and Heat Transfer for the Air-Cooled Condenser

Numerical Simulation of Heat Transfer Characteristics of Finned Tube Heat Exchanger at Different Flow Velocities

Numerical Simulation of Performance of Fin-and-tube Condenser with Different Structural Arrangement in Air-conditioning System

Simulation and Optimization of CO2 Fin-tube Gas Cooler

A thermal calculation model for tubular condensing heat exchanger

Numerical simulation of convection condensation heat transfer of H-fixed tubes with wet flue gas

Numerical Simulation on Fluid Flow and Coupled Heat Transfer for the Air-Cooled Condenser

Simulation and Optimization Study on the Performance of Fin-and-Tube Heat Exchanger

A numerical model for convective-condensation heat transfer of flue gas and its application on fin efficiency calculation

Experimental Study Of Water Cooled Condenser Made Of Three Dimensional And High Fin Density Integral-Finned Tubes