Abstract:This study presents an adaptive algorithm for distance relays. In this algorithm, the network connected to the transmission line terminals are modelled using an equivalent circuit, and the impedances of this equivalent circuit are estimated. By employing this algorithm, relay errors (over/under reach) caused by changes in network structure, the presence of fault resistance, and injected current from the remote end of the transmission line are eliminated. As a result, the relay accurately determines fault location and fault resistance, enhancing the performance of its Zone1 and Zone2 functions. Faults in power systems occur for various reasons, such as aging or natural disasters. Detecting, locating, and promptly clearing these faults is crucial for maintaining the safety and reliability of transmission lines (TLs). Distance relays (DRs), which protect TLs, detect faults, estimate their location, and send the required commands. However, these relays may experience mis‐detection due to manipulated impedance arising from both internal and external factors. These factors include measurement device errors, network topology changes, the presence of fault resistance (FR), and injected currents from remote line terminals. To address this challenge, an innovative adaptive protection scheme that considers FR, changes in network topology, and injected current from the opposite end of the line is proposed. By estimating the equivalent circuit impedances (ECIs) of the network connected to the terminal of the TL, this protection scheme utilizes impedance estimation techniques at the line terminals and offline network information. Simulation studies (tested on the IEEE 39‐bus standard network) show that the proposed scheme accurately estimates fault location (FL) and FR with high precision. The simulation results demonstrate its effectiveness in improving the performance of conventional distance protection relays in both the first and second protection zones (Zone1 and Zone2 ).

Effect of Reactive Equivalent Fault Impedance on Distance Protection

A Novel Adaptive Distance Protection Based on Impedance Locus Estimation

New Type Adaptive Distance Relay with Improved Performance

Distance Protection Principle for Series Compensated Lines Based on the Impedance Angle of the Compensated Point

Adaptive Distance Relay for Preventing Error Action of Reactive Fault

Impact of zero-sequence mutual inductance in UHV Anhui-to-east power transfer lines on phase-earth distance protection

Error Analysis of Distance Relay Protection in Phase-to-Phase Short Circuit Fault

An Incremental Quantities Distance Protection Using Park's Transformation

Improved time-domain distance protection based on fault active control for long transmission lines of PV/BES hybrid power generation system

Adaptive Distance Protection Based on the Analytical Model of Additional Impedance for Inverter-Interfaced Renewable Power Plants During Asymmetrical Faults

An Identification Method of Single-phase Permanent Fault at Transmission Lines with Shunt Reactors

A new scheme to identify the nature of the second reflection wave in travelling wave based distance protection

Improved Setting Method of Distance Protection with the SSFCL

An adaptive distance protection scheme considering fault resistance, injected current, and structural changes in the power system

NON-COMMUNICATION PROTECTION OF DOUBLE-CIRCUIT LINE SYSTEMS Part One Fault Analysis and Protection Principle

A novel distance protection for MMC-HVDC lines based on the equivalent capacitance voltage

Distance Protection That Insensitive to Power Swing

Adaptive non-communication protection for transmission lines. Part I: Fault analysis and protection principle

A New Protection Scheme for High Impedance Fault Using Adaptive Trip and Reclosure Technique

Performance analysis of multiphase compensated distance relay in single-phase-to-ground fault with power swing

Measured Impedance and Threshold Value of Electrode Line Impedance Supervision Based Protection in HVDC Transmission System