Abstract:Pressure-induced structural modifications in high-entropy alloys with varying Al contents, AlxCoCrFeNi (x = 0, 0.1, 0.3, 0.75, 1.5), have been investigated at pressures up to ∼50 GPa by synchrotron X-ray diffraction and, following depressurization, by transmission electron microscopy (TEM). In AlxCoCrFeNi compounds with x ≤ 0.3, all of which exhibit an initial single-phase face-centered cubic (fcc) structure, proportionality between the Al content and the critical pressure for transformation to hexagonal close-packed (hcp) phases, distinguished by a distinct planar stacking sequence, is observed. This is attributed to the structural distortion arising from the large size of Al atoms relative to those of the other constituent elements, which results in an increase in the formation energy of stacking faults and a decrease in compressibility. High-resolution TEM results demonstrate variation of the stacking sequence from ABCABC, typical of fcc materials, to ABABAB, typical of hcp materials, in CoCrFeNi following high pressure. In Al0.75CoCrFeNi, which exhibits an initial dual-phase structure [fcc and body-centered cubic (bcc)], the result again shows the formation of a (hcp) phase despite its higher Al content, suggesting that the bcc phase may be more amenable to pressure-induced phase modification than is the fcc phase, which is absent for lower Al contents. However, the trend of transformation inhibition by increasing the Al content is again observed, with Al1.5CoCrFeNi retaining its initial structure up to the highest pressure achieved. Determination of these compositional trends in the high-pressure phase response of these materials may enable the production of new phase mixtures with precisely tuned phase proportions and potentially desirable properties.

Phase Transformation Of Beta-Fesi2-Based Alloys Under In-Situ High-Temperature And High-Pressure X-Ray Diffraction Measurements

Phase transformation of /spl beta/-FeSi/sub 2/-based alloys under in-situ high-temperature and high-pressure X-ray diffraction measurements

Phase Transformation in Co-, Mn-, and Al-doped Iron Disilicide Alloys

Kinetics of SS-Phase Transformation in the Heat Treatment of FeSi2- and Fe2Si5-based Thermoelectric Alloys

Preparation and Thermoelectric Properties of Melt-Spun Fe2si5 Based Alloys

Mid-temperature Thermoelectric Performance of Zone-Melted Sb2(Te,Se)3 Alloys Near Phase Transition Boundary

Grain Size Effect on the Phase Transformations of Higher Manganese Silicide Thermoelectric Materials: an in Situ Energy Dispersive X-Ray Diffraction Study

Transport Properties of Rapid Solidified Fe–Si–Mn–Cu Thermoelectric Alloys

Preparation and Thermoelectric Properties of Melt-Spun Fe 2Si5 Based Alloys

Phase Transformations of Al-bearing High-Entropy Alloys AlxCoCrFeNi (x=0, 0.1, 0.3, 0.75, 1.5) at High Pressure

Influence Of Pre-Annealing And Mn Plus Al Double Doping On The Microstructure And Thermoelectric Properties Of Iron Disilicide

Phase stability of a eutectic high entropy alloy under extremes of pressures and temperatures

Synthesis of Crystalline Beta-Fesi2 under High-Temperature and High-Pressure

Anomalous phase transformation in magnetostrictive Fe81Ga19 alloy

Crystal Structure and Phonon Density of States of FeSi up to 120 GPa

Phases, microstructure and mechanical properties of Al x CoCrFeNi high-entropy alloys at elevated temperatures

Influence of Nitrogenizing and Al-doping on Microstructures and Thermoelectric Properties of Iron Disilicide Materials

Influence of Pre-annealing on the Microstructure and Thermoelectric Properties of Mn + Al Doped Iron Disilicide Prepared by Rapid Solidification and Hotpressing

Investigation of Intermediate Phases and Phase Transition Temperature of Α/β in the Zr-Sn-Nb-Fe Alloy

Microstructures and thermoelectric properties of Co-doped iron disilicides prepared by rapid solidification and hot pressing

On the Solidification and Phase Stability of a Co-Cr-Fe-Ni-Ti High-Entropy Alloy