Abstract:According to the present experiment results about the transformation from β-AlFeSi to α-Al(FeMn)Si phase in Al-Mg-Si series alloys, the model and kinetics of phase transformation, and microstructure evolution at 555°C were systematically investigated. The results show that, the homogeneous temperature T can give a significant effect on the transformation kinetics, and with increasing T, the transformation rate increases fast. The nucleus radius of α phase only affects the breakthrough time along the thickness direction of β phase. The distance l between two α phases mainly has an influence on the dissolving of rim for β phase. The thickness of β phase normally has a greatest influence on the phase transformation β → α, especially for the breakthrough stage of β phase, with increasing the thickness of β phase, the main transformation with longer time in the whole phase transformation process can changes from rim dissolving of β phase to breakthrough along the thickness direction of β phase. The breakthrough time of β phases with the thickness of 0.1, 0.2 and 0.3 μm is above 5, 10 and 15 h, respectively, which corresponds with the real experiment results. In addition, if the thickness of β phase is smaller than 0.3 μm, the transformation rate f(α) easily reaches above 0.9 after homogeneous heat treatment at 555°C for 16-24 h. Therefore, the importance of optimizing casting process to make sure the thickness of β phase below 0.3 μm, is the same as the homogeneous heat treatment for the better controlling the phase transformation β → α. © Copyright.

Kinetics of SS-Phase Transformation in the Heat Treatment of FeSi2- and Fe2Si5-based Thermoelectric Alloys

Phase Transformation Of Beta-Fesi2-Based Alloys Under In-Situ High-Temperature And High-Pressure X-Ray Diffraction Measurements

Phase transformation of /spl beta/-FeSi/sub 2/-based alloys under in-situ high-temperature and high-pressure X-ray diffraction measurements

Preparation and Thermoelectric Properties of Melt-Spun Fe2si5 Based Alloys

Phase Transformation in Co-, Mn-, and Al-doped Iron Disilicide Alloys

Preparation and Thermoelectric Properties of Melt-Spun Fe 2Si5 Based Alloys

The Effect of Heat Treatments on the Microstructural Evolution of Twin-Roll-Cast Al-Fe-Si Alloys

Corelation between the crystallisation process and change in thermoelectromotive force for the amorphous alloy Fe89.8Ni1.5Si5.2B3C0.5

Transport Properties of Rapid Solidified Fe–Si–Mn–Cu Thermoelectric Alloys

Microstructure development of Fe2Si5 thermoelectric alloys during rapid solidification, hot pressing and annealing

Study on the kinetics of phase transformation β → α in the homogeneous heat treatment of Al-Mg-Si series alloys

Kinetics and thermodynamics of thermally induced structural transformations of amorphous Fe75Ni2Si8B13C2 alloy

Effect of Annealing and Heating/Cooling Rate on the Transformation Temperatures of Nifega Alloy

Phase constitution, microstructure evolution and magnetocaloric properties of LaFe<sub>11.8</sub>Si<sub>1.2</sub> strip-casting flakes

Influence of Heat Treatments on Martensitic Transformations and Elastocaloric Effect in Two-Phase (β + γ) NiFeGa Alloys

Polymorphic transformation and elemental diffusional controlled phase spheroidization of eutectic VNbTiSi medium entropy alloy during heat treatment

Phases Formation and Evolution at Elevated Temperatures of Al–12Si–3.8Cu–2Ni–1Mg Alloy†

Phase Transformation Behavior of a Β-Solidifying Γ-Tial-based Alloy from Different Phase Regions with Various Cooling Methods

Anomalous phase transformation in magnetostrictive Fe81Ga19 alloy

Amorphous-to-Cu51Zr14phase Transformation in Cu60Ti20Zr20alloy

A Jmak-Like Approach For Isochronal Austenite-Ferrite Transformation Kinetics In Fe-0.055 Wt-%N Alloy