Abstract:The plate-like Fe-rich intermetallics phases in the recycled Al-Si alloys significantly deteriorate the mechanical properties. In this study, the effect of Mn addition on Fe-rich phases formation and the properties of the Al-7Si-1.2Fe alloys were systematically studied by optical microscopy, scanning electron microscopy, differential scanning calorimetry, thermodynamic calculations, synchrotron X-ray radiography and tomography. The results show that with the addition of Mn, the two-dimensional (2D) morphology of the Fe-rich phase change from plate-like to Chinese-script and star-like. The synchrotron X-ray tomography results indicate that the three-dimensional (3D) morphology of Fe-rich phases change from interconnected plate-like to separated hollow polyhedron with increasing Mn content. The in-situ synchrotron X-ray radiography results reveal that the formation temperature, size, and area fraction of the primary Fe-rich phase in the Al-7Si-1.2Fe-1.09Mn alloy gradually decreased, but the number density increased as the cooling rate increased. The thermodynamic calculation results indicate that β-Al5FeSi could be eliminated when the Mn content exceeded 1.06%, which was consistent with the experimental results. However, excessive Mn addition caused the formation of large primary Fe-rich phases, resulting in a significant reduction in the elongation of the alloys. Reducing the equilibrium partition coefficient difference of Mn and Fe and reducing the formation of primary Fe-rich phases with high Mn/Fe ratios are good strategies to neutralize the negative effect of Fe-rich phases.

Phase Transformation in Co-, Mn-, and Al-doped Iron Disilicide Alloys

Phase Transformation Of Beta-Fesi2-Based Alloys Under In-Situ High-Temperature And High-Pressure X-Ray Diffraction Measurements

Phase transformation of /spl beta/-FeSi/sub 2/-based alloys under in-situ high-temperature and high-pressure X-ray diffraction measurements

Effect of Co Addition on the Phase Structure and Magnetic Properties of Fe-Si-Al Alloys

In-Situ X-Ray Diffraction Study on Mlni(3.75)Co(0.75)Mn(0.3)Al(0.2) During Electrochemical Hydriding-Dehydriding Process

Influence Of Pre-Annealing And Mn Plus Al Double Doping On The Microstructure And Thermoelectric Properties Of Iron Disilicide

Influence of Nitrogenizing and Al-doping on Microstructures and Thermoelectric Properties of Iron Disilicide Materials

Kinetics of SS-Phase Transformation in the Heat Treatment of FeSi2- and Fe2Si5-based Thermoelectric Alloys

Influence of Pre-annealing on the Microstructure and Thermoelectric Properties of Mn + Al Doped Iron Disilicide Prepared by Rapid Solidification and Hotpressing

Transport Properties of Rapid Solidified Fe–Si–Mn–Cu Thermoelectric Alloys

Grain Size Effect on the Phase Transformations of Higher Manganese Silicide Thermoelectric Materials: an in Situ Energy Dispersive X-Ray Diffraction Study

Microstructure development of Fe2Si5 thermoelectric alloys during rapid solidification, hot pressing and annealing

Microstructures and thermoelectric properties of Co-doped iron disilicides prepared by rapid solidification and hot pressing

Phase Diagram and Annealing Effect for Fe1+δTe1−xSxsingle Crystals

Preparation and Thermoelectric Properties of Melt-Spun Fe2si5 Based Alloys

Preparation and Thermoelectric Properties of Melt-Spun Fe 2Si5 Based Alloys

Phase transformation and magnetic properties of MnAl powders prepared by elemental-doping and salt-assisted ball milling

Microstructures and Thermoelectric Properties of Fe0.92Mn0.08Six Alloys Prepared by Rapid Solidification and Hot Pressing

Thermoelectric Properties of Mn Doped FeSix Alloys Hot-Pressed from Nitrided Rapidly Solidified Powders

Phase diagram, ferromagnetic martensitic transformation and magnetoresponsive properties of Fe-doped MnCoGe alloys

Study of the evolution mechanisms of Fe-rich phases in Al-Si-Fe alloys with Mn modification using synchrotron X-ray imaging