Abstract:The phase structure, the magnetostructural transition behavior and the associated magnetocaloric effect have been investigated in Ni40Co10Mn40Sn10 bulk and powders, mainly focusing on the effects of annealing temperatures ranging from 573 K to 773 K. A non-modulated martensitic structure was detected in the bulk and as-ground powders, but a seven-layered orthorhombic structure was observed after annealing. The magnetostructural transition in the bulk alloy from weak magnetic martensite to ferromagnetic austenite was also confirmed in the as-ground and annealed powders. Compared with the bulk alloy, the transition temperatures of the as-ground powders decreased markedly; the transition temperature hysteresis broadened, and the magnetization change across the transition was severely reduced. With increasing annealing temperatures, the parameters of the magnetostructural transition gradually improved. When the powders were annealed at 773 K, the magnetostructural transition behaved the most similar to the bulk alloy. Consequently, the large magnetic entropy change of 27 J/(Kg K) and the effective cooling capacity of 171.3 J/Kg that were obtained under the magnetic field of 5 T were very close to the bulk alloy. The internal stress and surface effects were considered to understand the observed phenomena. (C) 2016 Elsevier B.V. All rights reserved.

Influence of Pre-annealing on the Microstructure and Thermoelectric Properties of Mn + Al Doped Iron Disilicide Prepared by Rapid Solidification and Hotpressing

Influence Of Pre-Annealing And Mn Plus Al Double Doping On The Microstructure And Thermoelectric Properties Of Iron Disilicide

Microstructures and thermoelectric properties of Co-doped iron disilicides prepared by rapid solidification and hot pressing

Influence of Nitrogenizing and Al-doping on Microstructures and Thermoelectric Properties of Iron Disilicide Materials

Microstructure development of Fe2Si5 thermoelectric alloys during rapid solidification, hot pressing and annealing

Microstructures and Thermoelectric Properties of Fe0.92Mn0.08Six Alloys Prepared by Rapid Solidification and Hot Pressing

Thermoelectric Properties of Mn Doped FeSix Alloys Hot-Pressed from Nitrided Rapidly Solidified Powders

Phase Transformation in Co-, Mn-, and Al-doped Iron Disilicide Alloys

Electric Transport Properties of Aluminium Doped Iron Disilicide Thermoelectric Materials

Microstructures and Thermoelectric Properties of Higher Manganese Silicide Prepared by Rapid Solidification and Hot Pressing

Transport Properties of Rapid Solidified Fe–Si–Mn–Cu Thermoelectric Alloys

Preparation and Thermoelectric Properties of Melt-Spun Fe2si5 Based Alloys

Rapid Annealing Optimizing Magnetic Softness and Thermal Stability of Mn-Substituted Fe-Based Nanocrystalline Alloys

Preparation and Thermoelectric Properties of Melt-Spun Fe 2Si5 Based Alloys

Phase transformation and magnetic properties of MnAl powders prepared by elemental-doping and salt-assisted ball milling

Microstructures and Magnetic Properties of Rapidly Solidified MnAl Alloys Modified with Indium

Electrical Properties of P-type FeSi_2 Based Thermoelectric Materials Doped with Sm and Mn

Thermoelectric Properties of Mnsi1.7 Films with Addition of Aluminum and Carbon

Effect of ball milling on the phase constitution and microstructure of induction melted Higher Manganese Silicides and their thermoelectric properties

Preparation of n-type nano-scale MnSi1.7 films by addition of iron

Influence of Annealing Temperatures on the Magnetostructural Transition and Magnetocaloric Effect of Ni40Co10Mn40Sn10 Powders