Abstract:Tetrahedrite (C12Sb4S13) has attracted attention as a p-type thermoeletric material with very low thermal conductivity induced by the anharmonic oscillation of Cu due to the lone-pair electrons of Sb. Many studies have been conducted to improve its thermoelectric performance by partially substituting the transition elements for the Cu sites. In this study, Fe-doped tetrahedrites Cu12-xFexSb4S13 (x = 0.1-0.4) were prepared by mechanical alloying and hot pressing. The tetrahedrite phase was successfully synthesized by mechanical alloying without post-annealing and exhibited stability even without phase transition after hot pressing. Moreover, the Fe content was observed to be directly proportional to the lattice constant, which confirmed the Fe substitutions on the Cu sites. The electrical conductivity was observed to decrease with the increase in the Seebeck coefficient due to the charge compensation caused by Fe doping (electron donation). The highest power factor was 0.84 mWm-1K-2 at 723 K for the specimen with x = 0.1; however, it decreased with an increase in Fe content. In addition, as the Fe content increased, the electronic thermal conductivity decreased. Thus, the lowest thermal conductivity value was obtained for the specimen with x = 0.4 (0.45–0.64 Wm-1K-1) in the temperature range of 323–723 K. As a result, the maximum value of the dimensionless figure of merit (ZT = 0.80) was achieved at 723 K for the specimen with x = 0.2.

Electrical Properties of P-type FeSi_2 Based Thermoelectric Materials Doped with Sm and Mn

TRANSPORT PROPERTIES OF P-TYPE FeSi2 BASED ALLOY DOPED WITH SAMARIUM AND CHROMIUM

Electrical properties of Fe-Sm-Si thermoelectric alloys

Effects of Co on Transport Properties of Sm-doped FeSi2 Based Thermoelectrical Material

Preparation and Thermoelectric Properties of Melt-Spun Fe2si5 Based Alloys

Preparation and Thermoelectric Properties of Melt-Spun Fe 2Si5 Based Alloys

Transport Properties of Fe-Si-Mn Based Thermoelectric Alloys Doped with Carbon, Germanium

Influence Of Pre-Annealing And Mn Plus Al Double Doping On The Microstructure And Thermoelectric Properties Of Iron Disilicide

Electrical properties of iron disilicide thermoelectric materials containing samarium

Thermoelectric Properties of Mn Doped FeSix Alloys Hot-Pressed from Nitrided Rapidly Solidified Powders

Fabrication and thermoelectric properties of TiFeSb system half-heusler compounds

Unexpected p-type thermoelectric transport arising from magnetic Mn substitution in Fe2V1-xMnxAl Heusler compounds

First-Principles Study on Mn-Doped TiFeSb Half-Heusler Thermoelectric Materials

Isoelectronic Re-Ge-codoped Higher Manganese Silicides with Enhanced Thermoelectric Properties Via Band Optimization, Charge Transfer, and Phonon Scattering

High Temperature Thermoelectric Properties and Energy Transfer Devices of Ca3Co4−xAgxO9 and Ca1−ySmyMnO3

Magnetic Iron Doping in Cu2SnS3 Ceramics for Enhanced Thermoelectric Transport Properties

Thermoelectric Properties of P‐type Higher Manganese Silicide Films Prepared by Solid Phase Reaction and Reactive Deposition

Thermoelectric Performance of Li Doped, P-Type Mg2(Ge,Sn) and Comparison with Mg2(Si,Sn)

Influence of Pre-annealing on the Microstructure and Thermoelectric Properties of Mn + Al Doped Iron Disilicide Prepared by Rapid Solidification and Hotpressing

Synthesis of Fe-Doped Tetrahedrites Cu<sub>12-x</sub>Fe<sub>x</sub>Sb<sub>4</sub>S<sub>13</sub> and Characterization of Their Thermoelectric Properties

Lead-Free Mnte Mid-Temperature Thermoelectric Materials: Facile Synthesis, P-Type Doping And Transport Properties