Abstract:This paper considers the stress-induced phase transitions of shape memory alloy slender cylinder, and analytically studies the phase transition process and the associated instability. A three-dimensional (3D) phenomenological model with an internal variable is adopted, which is simplified to a 1D system of two strains in three regions (austenite, martensite and phase transition regions). Suitable boundary conditions and interface conditions are proposed. Theoretically, it is a free boundary problem, as the position and shape of phase interfaces are unknown. We then focus on planar interfaces (which are energetically favored), and a symmetric case when phase transition occurs in the middle. For given applied stress, two-region solutions, three-region solutions and the connecting solutions between them are obtained analytically or semi-analytically, including many period-k solutions. Two-region solutions show that phase transition does not take place at one point, but simultaneously in a small region. The width of phase transition region is found analytically, revealing the roles of the material and geometrical parameters. Three-region solutions represent localized inhomogeneous deformations in experiments, and capture that the stress stays almost at the Maxwell stress during propagation of transformation front. For displacement-controlled process, the transition process is demonstrated by the stress-strain curve, which captures the stress drop/rise and the transition from homogeneous deformations to period-1 localized inhomogeneous deformations. When the radius is smaller than a critical value (given by material constants), the stress drop is very sharp due to transition of solutions in a snap-back bifurcation. These features show good agreement with experimental observations and shed light on the difficulties of numerical simulations.

IN SITU RESISTANCE ANALYSIS ON TRANSFORMATION OF CONSTRAINED Fe-Mn-Si-Cr-Ni SHAPE MEMORY ALLOY

Stabilization of deformed stress-induced martensite and its effect on shape memory effect in an Fe-Mn-Si-Ni-Co alloy

Fe–Mn–Si–Cr–Ni Based Shape Memory Alloy: Thermal and Stress-Induced Martensite

Strain Engineering in Ni-Co-Mn-Sn Magnetic Shape Memory Alloys: Influence on the Magnetic Properties and Martensitic Transformation

In Situ Observation of Thermoelastic Martensitic Transformation of Cu-Al-Mn Cryogenic Shape Memory Alloy with Compressive Stress

In-Situ High-Energy Synchrotron X-Ray Diffraction Study of Micromechanical Behavior of Multiple Phases in Ni47ti44nb9 Shape Memory Alloy

In-situ TOF Neutron Diffraction Studies of Cyclic Softening in Superelasticity of a NiFeGaCo Shape Memory Alloy

Deformation Dependence of Transformation Behavior of Ti-Ni-Nb Wide Hysteresis Shape Memory Alloy

Influence of applied stress on shape memory characteristics of Ni50Ti45Cu5 (at.%) alloy subjected to thermomechanical cycling

Transformation Behaviors and Superelasticity of Ti 50 Ni 48 Fe 2 Shape Memory Alloy Subjected to Cold-Rolling and Subsequent Annealing

Experimental Investigation on the Mechanical Instability of Superelastic NiTi Shape Memory Alloy

Microstructural mechanism underlying the stress recovery behavior of a Fe–Mn–Si shape memory alloy

Microstructural features, martensitic transformation, and functional properties of multicomponent Ti–Ni based shape memory alloys

Larger recovery strains in cast Fe‐Mn‐Si‐based shape memory alloys by reducing thermal activation and optimizing Mn content

Analytical study on phase transition of shape memory alloy wire under uniaxial tension

Microstructure, Martensitic Transformation and Superelasticity of Ti49.6Ni45.1Cu5Cr0.3 Shape Memory Alloy

Structure and Martensitic Transformation in Rapidly Solidified CoNiAlFe Alloy

In Situ Observation on Temperature Dependence of Martensitic Transformation and Plastic Deformation in Superelastic NiTi Shape Memory Alloy

Microstructure, Martensitic Transformation And Superelasticity Of T1(49) (6)N1(45 1)Cu(5)Cr(0 3) Shape Memory Alloy

Quantitative analysis of microstructure evolution in shape memory alloys during martensitic transformation

Coexistence of strain glass transition and martensitic transformation in highly nickel-rich ferroelastic alloy with large elastocaloric effect