Abstract:This paper considers the stress-induced phase transitions of shape memory alloy slender cylinder, and analytically studies the phase transition process and the associated instability. A three-dimensional (3D) phenomenological model with an internal variable is adopted, which is simplified to a 1D system of two strains in three regions (austenite, martensite and phase transition regions). Suitable boundary conditions and interface conditions are proposed. Theoretically, it is a free boundary problem, as the position and shape of phase interfaces are unknown. We then focus on planar interfaces (which are energetically favored), and a symmetric case when phase transition occurs in the middle. For given applied stress, two-region solutions, three-region solutions and the connecting solutions between them are obtained analytically or semi-analytically, including many period-k solutions. Two-region solutions show that phase transition does not take place at one point, but simultaneously in a small region. The width of phase transition region is found analytically, revealing the roles of the material and geometrical parameters. Three-region solutions represent localized inhomogeneous deformations in experiments, and capture that the stress stays almost at the Maxwell stress during propagation of transformation front. For displacement-controlled process, the transition process is demonstrated by the stress-strain curve, which captures the stress drop/rise and the transition from homogeneous deformations to period-1 localized inhomogeneous deformations. When the radius is smaller than a critical value (given by material constants), the stress drop is very sharp due to transition of solutions in a snap-back bifurcation. These features show good agreement with experimental observations and shed light on the difficulties of numerical simulations.

Analytical study on phase transition of shape memory alloy wire under uniaxial tension

Phase Transformations and Shape Memory Effects in Finite Length Nanostructures

An Analytical Study of the Instability of A Superelastic Shape Memory Alloy Cylinder Subject to Practical Boundary Conditions

Phase Transformation Behavior of Pseudoelastic Niti Shape Memory Alloys under Large Strain

Phase transitions induced by extension in a slender SMA cylinder: Analytical solutions for the hysteresis loop based on a quasi-3D continuum model

Analytical Study on Stress-Induced Phase Transitions in Geometrically Graded Shape Memory Alloy Layers. Part I: Asymptotic Equation and Analytical Solutions

Impact Induced Phase Transformation in Shape Memory Alloys

Analysis of a Shape Memory Alloy Plate with a Circular Hole Subjected to Biaxial Tension

Experimental Study of One‐dimensional Superelastic Capability of a Nearly Equi‐atomic NiTi Shape Memory Alloy

Effect of Thermomechanical Coupling on Stress-Induced Martensitic Transformation Around the Crack Tip of Edge Cracked Shape Memory Alloy

On Phase Transition Velocities of NiTi Shape Memory Alloys

Analytical Study on the Stress-Induced Phase or Variant Transformation in Slender Shape Memory Alloy Samples

On the Formation of Martensite in Front of Cracks in Pseudoelastic Shape Memory Alloys

Investigation on Stress Field near Crack-Tip of Mode I in Shape Memory Alloy

A One-Dimensional Constitutive Model for NiTi Shape Memory Alloys Considering Inelastic Strains Caused by the R-phase Transformation

A model of phase transition from austenite to martensite in single-crystal NiMnGa alloys

One-dimensional modeling of stress-induced transformation behaviour of shape memory alloy

Analysis of the Stress-Strain Curves of a Fe-Mn-Si Shape Memory Alloy

An internal-variable rod model for stress-induced phase transitions in a slender SMA layer. I: Asymptotic equations and a two-phase solution

Instabilities induced by phase transformation fronts coalescence during the phase transitions in a thin SMA layer: Mechanism and analytical descriptions

Phase-field Simulations of Thermomechanical Behavior of MnNi Shape Memory Alloys Using Finite Element Method