Abstract:Although much work has been done and significant progress has been made on partial discharges (PD) measurement and detection techniques, this is not the case for PD modeling. Four types of internal PD modeling, in sequential order from first to last developed, are three-capacitance (abc), induced charge concept (ICC), finite element analysis (FEA), and Multiphysics models. The abc model is too simple to provide an understanding of the physical phenomena affecting PD. In contrast, Multiphysics models are immature. Multiphysics models require a high number of physical parameters that need to be experimentally determined, which is not a trivial task. Moreover, adjusting the physical parameters to achieve a good agreement between simulation results and measurement results for a specific geometry and dimension may not work for other geometries and dimensions. The FEA model, a relatively recent model, and the ICC model, which fall between the abc and Multiphysics models in terms of modeling complexity, can partly explain mechanisms and physical phenomena associated with internal PD. However, to the best of our knowledge, there is only one paper comparing ICC and FEA models for a case study; thus, further research is needed to elucidate various aspects of these two models. In this paper, 1) an improved ICC and a FEA capable of describing phenomena occurring during PD are developed, 2) both developed models are coded and implemented either in MATLAB or in COMSOL Multiphysics linked with MATLAB, and their simulation results are compared and analyzed, and 3) the influence of different parameters including void shape, void size, and void air pressure on PD parameters are studied.

Study on Simulation Technology of Partial Discharge in Single Void Based on SIMULINK

Simulation On Power Characteristic Of Uhvdc During Commutation Failure And Dc Block

Study on Modifying the Simulation Model and Computating the Key Parameters of Partial Discharge in Single Void

Computer Simulation Of Partial Discharge In Void

Simulation of Partial Discharge Sequences Using Fluid Equations

Study On The Partial Discharge Characteristics In Different Solid And Gaseous Dielectric By Simulation

Measurement and Simulation of Partial Discharge in Disc-void of Oil-pressboard Insulation With Electrical Degradation Process

Critical Study of Partial Discharge Inception in Voids: Statistical Behavior to Stochastic Nature

Numerical Simulation Research on Partial Discharge of Particle Defects at Epoxy Interface Excited by High-Frequency Sinusoidal Voltage

Finite Element Simulation of the Partial Discharge Acoustic Wave Propagation Inside Power Transformers

Simulation of Ultrasonic Wave Propagation of Partial Discharge in Converter Transformer

Partial discharge modeling with increasing applied voltages across different void sizes

Simulation Of Partial Discharge Propagation Characteristics In Xlpe Cables And Joints

Measurement and Simulation of Partial Discharge in Oil Impregnated Pressboard with an Electrical Aging Process

Study Of The Influence Of Void Defect Size On Partial Discharge Characteristics In Solid Insulation

Simulation Study of the Relationship Between Partial Discharge and Ultrahigh-Frequency Electromagnetic Wave in GIS

Implementation of A Novel Double-Side Technique for Partial Discharge Detection and Location in Covered Conductor Overhead Distribution Networks

Numerical Modeling of Partial Discharges in a Solid Dielectric-bounded Cavity: A Review

Partial Discharge Characteristics and Mechanism in Voids at Impulse Voltages

Simulation Study on Propagation Characteristics of Optical Signal of Different Partial Discharge Defects

A Finite Element Analysis and an Improved Induced Charge Concept for Partial Discharge Modeling