Abstract:Traveling wave fault location methods have gained considerable growth over the years, with the anticipation that power systems will be accurate and reliable everywhere. But the performance of classical traveling wave methods has focused only on traditional current transformer measurement in the literature till date. Therefore, in this paper, an innovative non-contact measurement of traveling wave formulation is proposed to achieve accurate fault location and time of arrival detection on a two-terminal overhead transmission line, since power cable naturally generates magnetic and electrical fields in the surrounding atmosphere. The proposed method solitary depends on the first two and successive time differences between the incident and reflective wave from the fault point of the transmission line. Thus, the proposed scheme does not depend on current transformer measurement that stimulates the accuracy and reliability of the conventional traveling wave fault location method. To ensure an accurate time of arrival waves detection, we exploit the magnetic field sensor array on each tower to measure the quality of current traveling waves generated on the transmission line and locate the transient disturbances as a result of a short circuit. By analyzing the line energization, a comprehensive fault analysis on a 500-kV line was simulated with PSCAD/MATLAB toolbox compared to the two-terminal classical method. The sensitivity analysis demonstrated that the proposed method is much accurate and reliable to be deployed and cost-effective, making it highly useful and efficient in comparison to the classical two terminals traveling wave method with an average error of 0.014%. The effectiveness of the proposed method was verified by laboratory experimental setup.

Sinusoidal Steady-State Analysis for Fault Location in Power Distribution Systems

Locating Phase-To-Ground Short-Circuit Faults on Radial Distribution Lines

A Group of Single-Ended Time-Domain Line Fault Location Methods Using Breaker Operation Information

Fault Location Based on Synchronous Data of Both Ends in Non-effectively Grounded System

Single-ended traveling wave based fault location for single-phase-to-ground in power distribution lines

A Novel Single-Ended Fault Location Method for Locating Double-Phase to Earth Faults

Fault Location Method for Distribution Network Based on Synchronous Measurement

Distributed Fault Location Based on Comprehensive Analysis of Fault Current

Method and Simulation Analysis of Comprehensively Distributed Fault Location of Transmission Line

A novel noniterative single-ended fault location method with distributed parameter model for AC transmission lines

Time-Domain Transmission Line Fault Location Method With Full Consideration of Distributed Parameters and Line Asymmetry

Single Phase Line‐broken Fault Detection and Location Based on Differential Voltage in Radial Distribution Network

Reflected Traveling Wave Based Single-Ended Fault Location in Distribution Networks

A Distributed Fault Location Method For T-Connection Transmission Line

Fault Location in Overhead Transmission Line: A Novel Non-Contact Measurement Approach for Traveling Wave-Based Scheme

Fault Location Technology for Power System Based on Information About the Power Internet of Things

Fault Location Method for Distribution Networks Based on Leakage Energy Function

State Estimation Based Fault Location Method for Active Distribution Networks

Single-end Fault Location Technique for DC Distribution Lines Based on Network Topology and Measured Traveling Waves

Sequential Data-Based Fault Location for Single-Line-to-Ground Fault in a T-Connection Power Line

Fault Location Method Based on Full Waveform Information for Distribution Networks