Abstract:In Part I of this study, the benchmark test and signal calibration of contact and non-contact measurement to quantitatively assess the variation and difference between contact and non-contact measurements. Based on the research findings of Part I, non-contact multi-channel analysis of surface waves (MASW) technique and novel impact acoustic vibration method are proposed in Part II of this study. Aided by scanning Doppler laser vibrometer and a combination of conventional and high-frequency microphones, the feasibility of non-contact non-destructive test (NDT) for SCCS is validated using experimental measurements on steel plate-bonded reinforced concrete (RC) cube with preset interfacial debondings in various dimensions. Since the steel plate at the debonding regions loses the constraint of concrete core, its vibration mode changes obviously. Experimental observations indicate that the accurate location of interfacial debonding can be accurately recognized by non-contact stress wave measurement. Besides, the amplitude of impact-acoustic vibration signal increases remarkably while interfacial debonding occurs, and its frequency spectrum is obviously different from that of healthy regions. Contact NDT techniques, including the impact-response test and impact-transmission test, are also performed for further comparison. Research findings show that the non-contact vibration measurement exhibits high efficiency. More importantly, it can eliminate the test error induced by the additional mass and sensor sticking process. Difference in signal characteristics and imaging precision of contact and non-contact measurement is discussed in detail. In contrast, damage nephogram resolution based on signal amplitude is higher than that of the dominant frequency. Combined with Part Ⅰ of this study, which focuses on benchmark test and signal calibration, the research findings in this study can lay a solid foundation for improving the detection accuracy of interfacial debondings in SCCS using non-contact NDT techniques.

Non-destructive Test of Multiply Plywood Using ESSPI with Wide Audio-Frequency Driving Vibration

Electronic Speckle-Shearing Patten Interferometry for Vibration Analysis

Delamination Analysis of Carbon Fiber/Epoxy Composite Laminates under Different Loading Rates Using Acoustic Emission

Multi-time Lamb waves space wavenumber imaging method based on ultrasonic-guided wavefield

A New Quantitative Acoustic Emission Model for Damage Characterization of Composite Laminates Using Original Waveforms

Damage Detection For Laminated Composite Structures With Wavelet Analysis

The Study of Wood Knots Using Acoustic Nondestructive Testing Methods.

Elastic wave modes for the assessment of structural timber: ultrasonic echo for building elements and guided waves for pole and pile structures

The Depth Measurement of Internal Defect Based on Laser Speckle Shearing Interference

Interfacial Debonding Detection for Steel-Concrete Composite Structures Part II: Scanning Doppler Laser-Based MASW and Microphone Combination-Based Impact-Acoustic Vibration

Damage Detection Of Composite Laminates Based On Vibration Testing

Nondestructive Evaluation of Adhesive Joints in Layered Structures Using Nonlinear Measurements of Second Harmonics of Ultrasonic Lamb Waves

Multi-frequency instantaneous wavenumber damage imaging method based on ultrasonic guided waves induced by laser point-by-point excitation

Experimental Study on Damage Detection in Timber Specimens Based on an Electromechanical Impedance Technique and RMSD-Based Mahalanobis Distance

Non-Destructive Evaluation of Composite Laminates by Using Fiber Optic AE Sensor

Detection and Location of Defects in Laminated Veneer Lumber by Wavelet Package Analysis

Nondestructive Testing of Thin Composite Structures for Subsurface Defects Detection Using Dynamic Laser Speckles

Nondestructive evaluation with fully non-contact air-coupled transducer-scanning laser Doppler vibrometer Lamb wave system

Full-field Laser Vibration Measurement in NDT Techniques

Grain effect on the accuracy of defect detection in wood structure by using acoustic-laser technique