Abstract:Heterojunction with intrinsic thin-layer (HIT) solar cells attract attention due to their high open circuit voltage and stable performance. However, short circuit current density is difficult to improve due to light losses of transparent conductive oxide and hydrogenated amorphous silicon passivation (a-Si:H) layer and low absorption coefficient of crystalline silicon (c-Si). Silicon germanium alloy (Si/Si1-xGex) quantum wells and quantum dots are capable of improving low light utilization by strong optical absorption in the infrared region. In this article, opto-MoS2of the HIT solar cells integrated with Si/Si1-xGex quantum wells (HIT-QW) as a surface absorber are investigated by numerical simulation with Technology Computer Aided Design (TCAD). The influences of germanium content on the MoS2of HIT solar cells with long carrier lifetimes of Si1-xGex layers (p*) and defect-free a-Si:H/c-Si interface are investigated at first. The simulation results indicate that optical utilization in the infrared region is enhanced with the increase of germanium fraction, while open circuit voltage degrades due to the decreasing of the energy band gap of Si1-xGex, radiative recombination and auger recombination mechanism in the Si/Si1-xGex quantum wells. And the conversion efficiency reaches a maximum value at a germanium fraction of 0.25 then drops distinctly. When the germanium fraction increases from 0 to 0.25, the short circuit current density increases from 34.3 mA/cm2 to 34.8 mA/cm2, while the open circuit voltage declines from 749 mV to 733 mV. Hence, the conversion efficiency increases from 21.5% to 21.7% due to the fact that the enhancement of short circuit current density compensates for the reduction of open circuit voltage. When the germanium content increases to more than 50%, a serious open circuit voltage loss of more than 130 mV associated with the energy band gap loss of Si1-xGex arises in the HIT-QW solar cells, which indicates that the dominating carrier transport mechanism changes from shockley diffusion to recombination in the Si/Si1-xGex quantum wells. Subsequently, the influences of interface defects at a-Si:H/c-Si interface and bulk recombination centers in the Si/Si1-xGex quantum wells are discussed. Both interface holes at a-Si:H/c-Si interface and bulk holes in Si1-xGex quantum wells can be recombined through the interface defects at a-Si:H/c-Si interface and bulk recombination centers in the Si/Si1-xGex quantum wells, respectively, which restricts the position of hole fermi level in the open circuit condition. When the germanium fraction increases, the influence of interface defects at a-Si:H/c-Si interface becomes weak on the degradation of open circuit voltage compared with the significant influence of the bulk trap centers. Moreover, p* of longer than 510-5 s is necessary for the retention of electrical performance of HIT-QW solar cells by the simulation. Based on this research, high-efficiency HIT solar cells can be achieved by incorporating high-quality Si/Si0.75Ge0.25 quantum wells, which also requires the impactful passivation of a-Si:H/c-Si interface.

IMPACT OF WIDE BANDGAP P-TYPE NC-SI ON THE PERFORMANCE OF A-SI SOLAR CELLS

Influence of contact characteristics of SnO2/P on fill factor of solar cell

Improved Nanocrystal Formation, Quantum Confinement and Carrier Transport Properties of Doped Si Quantum Dot Superlattices for Third Generation Photovoltaics

Wide-bandgap Nanocrystalline Silicon-Carbon Alloys for Photovoltaic Applications

The graded optical band gap (GBG) in hydrogenated nanoamorphous silicon(na-Si:h) solar cells prepared by PECVD

Improvement of amorphous silicon n-i-p solar cells by incorporating double-layer hydrogenated nanocrystalline silicon structure

Effect of A-Si : H Interface Buffer Layer on the Performance of Hydrogenated Amorphous Silicon Germanium Thin Film Solar Cell

Wide Bandgap P-Type Nanocrystalline Silicon Oxide As Window Layer for High Performance Thin-Film Silicon Multi-Junction Solar Cells

Study on P-a-Si:H properties of N-type heterogeneous junction solar cells manufactured by large-area parallel plate PECVD machine

Silicon Nanocrystal Conjugated Polymer Hybrid Solar Cells with Improved Performance

Nanocrystalline‐silicon hole contact layers enabling efficiency improvement of silicon heterojunction solar cells: Impact of nanostructure evolution on solar cell performance

Numerical Simulation of Silicon Heterojunction Solar Cells with Si/Si1-xGex Quantum Wells

PHOTOELECTRIC STRUCTURE DESIGN OF HIGH EFFICIENCY AMORPHOUS SILICON GERMANIUM SOLAR CELL BASED ON LIGHT MANAGEMENT AND BAND GAP PROFILING

Widening Bandgap of I/n-a-si:H Window Layers Via Hydrogen Injection in Cat-CVD for SHJ Solar Cells

Role of the Buffer at the Interface of Intrinsic A-Si:H and P-Type A-Si:H on Amorphous/crystalline Silicon Heterojunction Solar Cells

Improvement in Performance of Hydrogenated Amorphous Silicon Solar Cells with Hydrogenated Intrinsic Amorphous Silicon Oxide P/i Buffer Layers

Mechanism Insight into the Effect of I/P Buffer Layer on the Performance of NIP-type Hydrogenated Microcrystalline Silicon Solar Cells

Improved Device Performance of Si-based Heterojunction Solar Cells by Using Phosphorus Doped Si Nanocrystals Embedded in SiC Host Matrix

Investigation of a-Si (N+)/c-Si (P) hetero-junction solar cell through AFORS-HET simulation

Improved Interface Microstructure Between Crystalline Silicon and Nanocrystalline Silicon Oxide Window Layer of Silicon Heterojunction Solar Cells

Bandgap Optimized III&#x2013;V (gaasp) Nanowire on Silicon Tandem Solar Cell, Device and Data