Abstract:Plastic-strain-controlled fatigue was performed on pure iron specimens with uniaxial symmetric tension-compression loadings at room temperature. The as-fatigued specimens were then annealed in vacuum at 1173 K from 1 to 7 hours. The morphologies of internal fatigue microcracks were observed by scanning electron microscopy (SEM) in the as-fatigued and as-annealed specimens. The density of the specimens was measured with an electronic analytical balance. The density of the as-fatigued specimens decreased continuously as the fractional fatigue life increased, and was nearly constant when the specimens were annealed up to 2 hours at 1173 K, but increased gradually after 2 hours of annealing time. The density of some specimens eventually approximates to the value of ρ 0, the initial density, at 7 hours of annealing time. This suggests that the initial decrease in density is due to crack initiation and propagation in the as-fatigued specimens. At the early stage of annealing, the specimen density is nearly constant because the crack morphological change is controlled by surface diffusion. At the later stages, the density increases and finally returns to the initial density because the spherical voids evolved from the parent crack are reduced by volume diffusion coupled with grain-boundary diffusion. A combined model is presented to predict the shrinkage of the spherical voids within the specimens, and is in broad agreement with the experimental data.

Diffusive Healing of Transgranular Fatigue Microcracks Within Alpha-Iron

Diffusive healing of intergranular fatigue microcracks in iron during annealing

MORPHOLOGICAL EVOLUTION OF INTERNAL FATIGUE MICROCRACKS IN Α-Iron DURING DIFFUSIVE HEALING

Morphological Evolution During Diffusive Healing of Internal Cracks Within Grains of Α-Iron

Diffusive Healing of Internal Fatigue Micro-Cracks in Pure Titanium

Diffusive Healing of Internal Fatigue Microcracks in Pure Magnesium

Morphological Healing Evolution of Penny-Shaped Fatigue Microcracks in Pure Iron at Elevated Temperatures

Density Changes of Iron During Morphological Healing Evolution of Internal Fatigue Microcracks

CHANGE IN DENSITY OF Α-Fe DURING HEALING OF INTERNAL FATIGUE MICROCRACKS UNDER ANNEALING

Cracking in a Fe–25Mn–3Si–3Al Steel

Restoration of Impact Properties of Internal Crack Healing in A Low Carbon Steel

Molecular dynamics simulation of fracture in α-iron

Microstructure and mechanical properties of internal crack healing in a low carbon steel

Strain Visualization of Growing Short Fatigue Cracks in the Heat-Affected Zone of a Ni–Cr–Mo–V Steel Welded Joint: Intergranular Cracking and Crack Closure

The mechanism of internal fatigue-crack initiation and early growth in a titanium alloy with lamellar and equiaxed microstructure

A study relating to the enhancement of transgranular fracture by iron in AlZnMg alloys

In-situ scanning electron microscopy studies of small fatigue crack growth in recrystallized layer of a directionally solidified superalloy

Evolution Behaviors and Mechanisms of Internal Crack Healing in Steels at Elevated Temperatures

Effect of Microstructure on Appearance of Near-Threshold Fatigue Fracture in Cr–Mo–V Steel

Dislocation interactions and crack nucleation in a fatigued near-alpha titanium alloy

Understanding the High-Temperature Fatigue Crack Growth from Exceptional Nano-α Phases and {10$$ \bar{1} $$2} Deformation Twins in Hot Deformed Titanium Alloy